JVC hr-dvs3u manual 78 EN

78 EN			TROUBLESHOOTING (cont.)
RECORDING
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	Recording cannot be started.	● For the VHS deck
		There is no cassette loaded, or the	Insert a VHS (or S-VHS) cassette, or using
		cassette loaded has had its record safety	adhesive tape, cover the hole where the
		tab removed.	tab was removed.
		● For the DV deck
		There is no cassette loaded, or the	Insert a Mini DV cassette, or set the erase
		cassette loaded has had its erase	protection switch set to “REC”.
		protection switch set to “SAVE”.
2.	TV broadcasts cannot be recorded.	● “L-1” or “F-1” has been selected as the	Set to the desired channel.
		input mode.
3.	Tape-to-tape editing using another	● The components have been incorrectly	Connect the components correctly
	component is not possible.	connected, or correct video connector	( pg. 56 – 62) or check “REAR AUX
		(S-VIDEO or VIDEO) is not selected.	INPUT” or “FRONT AUX INPUT” setting.
			( pg. 71, 73)
		● All necessary power switches have not	Confirm that all units’ power switches are
		been turned on.	turned on.
		● The input mode is not correct.	Set the input mode to “L-1” or “F-1”.
4.	Camcorder recording is not possible.	● The camcorder has not been properly	Confirm that the camcorder is properly
		connected.	connected. ( pg. 56)
		● The input mode is not correct.	Set the input mode to “L-1” or “F-1”.
5.	“[” on the front display panel won’t	● The end of the tape was reached during	The program may not have been recorded
	stop blinking.	recording.	in its entirety. Next time make sure you
			have enough time on the tape to record
			the entire program.
6.	Audio dubbing is not possible.	For the DV deck
		● “SOUND MODE” had been set to	Set “SOUND MODE” to “12BIT” at the
		“16BIT” at the original recording.	original recording. ( pg. 76)
		● The tape speed had been set to LP at the	Set the tape speed to SP at the original
		original recording.	recording.
7.	Monitoring the audio-dubbed sound is	● This is normal.	Set “12BIT MODE” to “SOUND 2” or
	not possible during audio dubbing		monitor the sound using the connected
	using the DV deck.		devices.
8.	The programed memory of Random	● The memory backup time has expired.	Perform Random Assemble Editing again.
	Assemble Editing is disappeared.		( pg. 64)
9.	When performing Tape Dubbing, the	● This is normal.	Locate the start point a little before the
	beginning of the dubbing start point is		point where you want to start dubbing.
	not dubbed.		( pg. 54, 55)