JVC HR-J695U manual Timer Recording, Recording Features, Express Timer Programing

PRESS (+/–, SP/EP, 8=DAILY 9=WEEKLY), THEN (0K) PRESS (PROG.) TO END

– –:––AMCH

– – – SP

– –:––AMDATE

– –/––/– –

STOP

START

PROGRAM 1

– Recording –

Recording Features

Specifying recording length

—Instant Timer Recording (ITR)

During recording, press REC (7) on the VCR repeatedly until the recording length you want appears on the display panel. The record indicator () on the display panel starts blinking.

●Each time you press the button, recording length increases in 30-minute intervals (up to 6 hours).

●The VCR shuts off after recording is finished.

●To cancel an ITR, press STOP (8) on the Remote or STOP/EJECT (0) on the VCR.

Watching one program while recording another

During recording…

●If you connect the TV and the VCR only using the RF connection to view pictures from the VCR, press TV/VCR on the Remote so that VCR mode indicator goes off from the display panel. (The TV broadcast being recorded disappears.)

●If you are using the AV connection to view pictures from the

VCR, change the TV’s input mode from AV to TV. Then, select the channel you want to watch, on the TV.

Second Audio Recording

This VCR’s built-in MTS decoder enables reception of Multichannel TV Sound broadcast. To record a SAP program received, set “2ND AUDIO RECORD” to “ON”. Refer to “2ND AUDIO RECORD – ON/OFF” in “Function Settings” section for detail.

Timer Recording

Up to 8 timer recording programs can be made using Express timer programing method as far as a year in advance. Remember, the clock must be set before you can program the timer.

NOTES:

●If all the 8 programs have already been set, “PROGRAM FULL” appears on the TV screen.

●After timer recording is completed, the VCR turns off automatically.

●You can program the timer recording while a regular recording is in progress; the menu screens will not be recorded.

●To timer-record cable or satellite channels, be sure to keep the cable box or DBS receiver turned on with the correct channel selected.

Express Timer Programing

Load a cassette with the record safety tab intact. The VCR turns on, and the counter is reset, automatically.

APress PROG. on the Remote to access Program screen.

B Press START+/–,STOP+/–,DATE+/– or CH+/– repeatedly to enter the start

time, stop time, date or channel. ● Press and hold START+/– or

STOP+/– to increase the time in 30-minute intervals.

● To set the tape speed, press SP/EP. ● To timer-record daily (Monday–

Friday) or weekly serials, press DAILY (M-F) or WEEKLY. Pressing the button again makes the “DAILY” or “WEEKLY” display disappear.

CPress OK or PROG..

●If “PROGRAM NOT COMPLETED PROGRAM OVERLAP” appears, refer to “Program overlap warning display”.

DPress TIMER. The VCR turns off automatically and “#” is displayed on the display panel.

Timer programing will be lost after a power failure occurs.

NOTE:

If the tape reaches its end during timer recording, the recording stops and “#”, “ ” and “ $” on the front display panel blink. Press TIMER to disengage timer, then press STOP/EJECT (0) on the VCR to eject the tape or press REW (3) to rewind the tape.