JVC HR-S29U manual Changing Remote Control Code, 52 EN, Check remote control code for VCR

52 EN 2MULTI-BRAND REMOTE CONTROL (cont.)

Changing

Remote Control

Code

				REW	FF
REC LINK
VIDEO (MONO)L—AUDIO—R			+
S-VHS ET	SP	EP	CH	REC	PAUSE STOP/EJECT
		VCR

This Remote is capable of transmitting two control codes; one set to respond to A code control signals and another set to respond to B code control signals.

This Remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily modify your VCR and the Remote to respond to B code signals.

When using two JVC VCRs, set two VCRs and their Remotes to different codes, so that you can operate these VCRs1separately.

1Set remote control code for Remote

2Press and hold A/B.

3Press the Number key “2”. Press OK, and release A/B.

●The Remote now can transmit B code control

2signals.

Check remote control code for VCR

Press and hold 3 on the VCR for more than

5 seconds while the VCR is turned off. The code

3currently set appears on the display panel.

Change code for VCR

Press any key on the Remote.

1 2 3

4 5 6

7 8 9

0

2

4

1–1, 3

1–2

●The VCR now responds to B code control signals.

●To set the Remote and the VCR back to A code control signals, repeat the same procedure as shown above except pressing the Number key “1” in step 2of 1.

To control two VCRs with the same Remote

You can control two JVC VCRs by switching the remote control1 code for the Remote between A and B ( step

), keeping two VCRs to different control codes.

1

3 –3

●Press the Number key “1” for A code control signals and the Number key “2” for B code control signals. (To change only the remote control code for the Remote, DO NOT perform steps 2and 3.)

(Ex.) To set Remote to B code:

MBR SET
A/B		E
		NTER/O
	2		SD	Release
		3	OK
Hold	Press in succession
down