Masterpage:Right
EN 15
Filename [HRS7700EU1.fm]
Page 15 March 8, 2000 1:13 pm
SAT CONTROL SET
Satellite Receiver Control Setting
The following procedure is required if you receive
satellite channels through a satellite receiver.
Approximately 20 seconds before the SHOWVIEW timer
programming (墌pg. 28) or Express timer programming
(墌pg. 30) starts, the recorder sets its input mode to “L-2”
and automatically switches the satellite receiver’s
channels using the provided Satellite Controller.

Installing Satellite Controller

ASituate the Satellite Controller.
Place the Satellite Controller so that the path between its
transmitter and the satellite receiver’s remote sensor is
unobstructed.
BAttach the Satellite Controller.
Fix securely using the adhesive strip attached on the back
of the Satellite Controller.
CMake connections.
Be sure to connect the recorder’s AV2 (L-2) IN/DECODER
connector to the satellite receiver’s 21-pin SCART
connector.
NOTE:
When connecting your satellite receiver, refer to its instruction
manual.
DConnect the Satellite Controller to recorder.
Connect the Satellite Controller to the SAT CTL connector
on the rear panel.
Satellite receiver
Satellite Controller
(suggested locations)
Transmitter
21-pin SCART
cable
(not provided)
SAT CTL
AV2 (L-2) IN/DECODER
Your recorder
Satellite Controller
Back of recorder
Satellite receiver
HRS7700EU1.fm Page 15 Wednesday, March 8, 2000 1:14 PM