50subsidiary information
SYMPTOM | POSSIBLE CAUSE | CORRECTIVE ACTION |
RECORDING
1.Recording cannot be started.
2.TV broadcasts cannot be recorded.
3.
4.Camcorder recording is not possible.
•There is no cassette loaded, or the cassette loaded has had its record safety tab removed.
•AV1 or AV2 has been selected as the input mode.
•The source (another VCR, camcorder) has not been properly connected.
•All necessary power switches have not been turned on.
•The input mode is not correct.
•The camcorder has not been properly connected.
•The input mode is not correct.
Insert a cassette, or using adhesive tape, cover the hole where the tab was removed.
Set to the desired preset.
Confirm that the source is properly connected.
Confirm that all units’ power switches are turned on.
Set the input mode to AV1 or AV2.
Confirm that the camcorder is properly connected.
Set the input mode to AV1 or AV2.
TIMER RECORDING
1. Timer recording won’t work. • The clock and/or the timer have been set incorrectly.
• The timer is not engaged.
• The loaded cassette has had its record safety tab removed.
Press oand confirm that the timer indicator is displayed on the display panel.
Remove the cassette and cover the hole with adhesive tape, or insert a cassette with the record safety tab intact.
2.The timer indicator blinks on the display panel.
3.Timer programming is not possible.
•The timer is engaged but there’s no cassette loaded.
•Timer recording is in progress.
Load a cassette with the record safety tab intact.
Timer programming can’t be performed while a timer recording is in progress. Wait until it finishes.
4.The VCR stops timer recording, rewinds the tape and ejects the cassette, then enters the standby mode automatically.
5.The VIDEO Plus+ system does not timer record properly.
• The end of the tape was | The programme may not have |
reached during timer recording. | been recorded in its entirety. Next |
| time make sure you have enough |
| time on the tape to record the |
| entire programme. |
• The VCR’s preset positions | Set the preset position manually. |
have been set incorrectly. | That preset position is registered |
| to the VCR. Then |
| procedure. |