JVC HR-VP638U manual Engage Insert Editing, END Insert Editing

INSERT

1	2	3
4	5	6
7	8	9
C.RESET	0
		PLAY

6

q

PLAY

		47
6	ENGAGE INSERT EDITING
	Press INSERT.
	● Your VCR enters the Insert-Pause mode. (REC, PLAY
	and PAUSE light up on the front display panel.)
	● The TV screen changes from the still picture to the
	input signal you are going to record.
7	START EDITING
	Load the source cassette and play back the segment
	that is to be inserted. Then press PLAY to start the tape
	in your VCR; Insert Editing begins at this point.
	● PLAY and REC are displayed on the front display
	panel.
8	END INSERT EDITING
	At counter "0H00M00S", Insert Editing will stop automati-
	cally while the tape continues running in the Play
	mode. if you wish to stop Insert Editing before the
	specified edit-out point, press C.RESET.

FOR AV INSERT EDITING

If you want to replace the picture, Hi-Fi audio soundtrack and normal audio soundtrack all at the same time...

In step 6 above, after you press INSERT, press A. DUB. also. (REC and PLAY blink and PAUSE lights up on the display panel.)

NOTES:

●Suitable leads can be obtained from your dealer.

●Insert editing is not possible with cassettes whose safety tab has been removed.

●In insert editing, the recording speed (SP/EP) is determined by the previous recording to be replaced. If the previous recording's speed changes within a single edit, the inserted picture will be distorted at the switching point.

●Insert Editing is also possible using the rear connectors. When using these connectors, be sure to select "REAR" at the Aux Input screen. To select the correct AUX Input connector, follow steps 4, 5, 9 – 11 from the "Edit From A Camcorder" section, ☞ pg 42.