JVC HR-VP682U manual Timer Recording

			EN 43
TIMER RECORDING
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	Timer recording will not work.	● The clock and/or the timer have	Set the clock and/or timer correctly.
		been set incorrectly.
		● The timer is not engaged.	Press TIMER and check to make sure
			that ä appears on the front display
			panel.
		● The VCR has not been set up properly.	Re-perform the set-up procedures.
			Make sure you have compensated for
			guide channel and VCR or cable box
			channel number mismatches
			(☞ pg. 26).
2.	Timer programing will not work.	● Timer recording is in progress.	Timer programing cannot be performed
			when timer recording is in progress.
			Wait until it finishes.
3.	ä and ] on the front display	● The timer is engaged but there is no	Load a cassette with the record safety
	panel will not stop blinking.	cassette loaded.	tab intact, or with the hole covered
			with adhesive tape.
4.	The cassette is automatically	● The loaded cassette has had its	Remove the cassette and cover its
	ejected, and ä and ] on the	record safety tab removed.	hole with adhesive tape, or replace it
	front display panel will not stop		with a cassette on which the safety
	blinking.		tab is intact.
5.	ä blinks for 10 seconds and the	● TIMER has been pressed when there	Check the programed data and set
	timer mode is disengaged.	are no programs in memory, or the	again if necessary, then press TIMER
		timer recording program has not	again.
		been set correctly.
6.	The cassette is automatically	● The tape reaches its end during	The program may not have been
	ejected, the power shuts off and ä	timer recording.	recorded in its entirety. Next time be
	and ] will not stop blinking.		sure you have enough time on the
			tape to record the entire broadcast.
7.	You moved, and now VCR Plus+	● The receivable stations in the new	Re-perform the VCR Plus+ setup
	does not work properly.	area are received on different	procedure (☞ pg. 26).
		channels than those in the previous
		area.
8.	“PROGRAM FULL” is displayed on	● All 8 programs of the VCR’s timer	Wait until a space in memory clears,
	the screen.	memory are used.	or cancel unnecessary program
			information (☞ pg. 30).
OTHER PROBLEMS
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	When scanning channels, some of	● Those channels have been preset to	If you need the skipped channels,
	them are skipped over.	be skipped.	restore them (☞ pg. 14).
2.	The channel cannot be changed.	● Recording is in progress.	Press PAUSE ( 8 ) to pause the
			recording, change channels, then
			press PLAY ( 3 ) to resume recording.
3. The Remote will not operate your		● The brand codes are set incorrectly.	Reset the correct brand codes (☞ pg.
	TV or cable box or DBS receiver.		38, 39 or 40).
4.	Even though Auto or Semiauto	● The clock setting data received from	Select a different host channel during
	Clock Set has been performed, the	the host channel is incorrect.	Semiauto Clock Set (☞ pg. 11), or
	clock is incorrect.		perform Manual Clock Set (☞ pg. 12).