Scan Mode Set (DVD deck only)

This unit supports the progressive scan system as well as the conventional interlaced scan system. If your TV equipped with component video connectors supports the progressive video input, you can enjoy a high quality picture by setting the progressive scan mode to active.

•Refer also to the instruction manuals supplied with your TV.

•If your TV equipped with component video connectors does not support the progressive video input, do not change the scan mode to the “PROGRESSIVE.”

•Turn on the TV and select the VCR channel (or AV mode).

•Slide the TV/VCR/DVD switch on the Remote to right.

Initial Settings

Plug&Play Set

Plug&Play setting starts automatically when you press POWER for the first time to turn on the unit.

•Turn on the TV and select the VCR channel (or AV mode).

•Slide the TV/VCR/DVD switch on the Remote to the right.

~Press POWER to perform Plug&Play setup.Ÿ Select language.

Press %fi to move the highlight bar (arrow) to your desired language, then press ENTER.

Introduction

Preparation

~Select the DVD deck.

Press VCR/DVD on the unit so that the DVD indicator lights up on the front display panel.

ŸSwitch the mode.

1 Press and hold PROGRESSIVE SCAN on the

unit for more than 3 seconds.

• The Clock Set screen appears.

! Set time.

Press %fi to set the hour, then press ENTER.

• Press and hold either

5

Operations on VCR Deck

The current scan mode blinks on the front display

panel.

2While the current scan mode blinks, press @ #

to select “(ProGr)” (for the progressive

scan mode) or “(IntEr)” (for the interlaced scan mode), then press ENTER.

•If the current scan mode stops blinking before you make the setting, start from step 1 again.

NOTE:

When the progressive scan mode is selected, the Progressive mode indicator ( ) lights up on the front display panel.

button to delay or advance the time by 30 minutes.

⁄Set date.

Press %fi to set the date, then press ENTER.

•Press and hold either button to change the date by 15 days.

@Set year.

Press %fi to set the year.

¤ Start auto channel set.

Press SET UP.

• Receivable channels in your area are automatically assigned to the CH+/– buttons, and non-receivable channels are skipped.

•If the tuner channels have been set properly “SCAN COMPLETED” will be displayed on the screen. If “SCAN COMPLETED–NO SIGNAL–” is displayed on the screen, make sure that the antenna cable is connected to the VCR properly and press ENTER on the Remote. The unit will try Auto Channel Set again.

#Press SET UP to return to normal screen.

Operations on DVD Deck

Advanced Operations

Additional Information

11