66 EN

EDITING (VCR DECK)

Edit From A

Camcorder

AIf the camcorder has no S-VIDEO output connector:Recorder

AUDIO input

To PAUSE

connector

VIDEO

 

input

 

Audio cable (not provided)

Video cable (not provided)

 

 

Mini-plug cable

VIDEO OUT

(not provided)

 

(JVC camcorder

AUDIO OUT

only)

 

Camcorder

 

Player

To EDIT

B If the camcorder has an S-VIDEO output connector:

S-VIDEO input

Recorder

You can use a camcorder as the source player and your unit as the recording deck.

Slide the TV/VCR/DVD switch to the right.

A Make connections.

AIf the camcorder has no S-VIDEO output connector:

—connect the camcorder’s AUDIO OUT and VIDEO OUT connectors to the unit’s front panel AUDIO and VIDEO input connectors.

BIf the camcorder has an S-VIDEO output connector:

—connect the camcorder’s AUDIO OUT and

S-VIDEO OUT connectors to the unit’s front panel AUDIO and S-VIDEO input connectors.

●When using a monaural camcorder, connect its AUDIO OUT connector to the AUDIO L input connector on your unit.

●When a Master Edit Control-equipped JVC camcorder is used, the camcorder is capable of controlling the unit. Refer to the camcorder’s instruction manual for operating procedure.

B Select the VCR deck.

On the unit

Press VCR/DVD repeatedly so that the VCR indicator lights up.

On the Remote

Press VCR so that the VCR indicator lights up.

C Set the unit’s input mode.

Press AUX (number key “0”) and/or CH to select “F-1”.

●When using S VIDEO connector, set “FRONT AUX INPUT” to “S-VIDEO”. ( pg. 77)

●When using VIDEO connector, set “FRONT AUX INPUT” to “VIDEO”. ( pg. 77)

D Set the edit mode.

See “PICTURE CONTROL” on page 74.

E Engage the Record Pause mode.

AUDIO input Audio cable (not provided)

S-Video cable (provided)

S-VIDEO OUT

AUDIO OUT

Camcorder

To PAUSE

connector

Mini-plug cable (not provided) (JVC camcorder only)

Use PLAY (4), REW (3), or FF (5) to locate the point where you start recording, then press and hold PAUSE (9) and press REC (7) to engage the Record Pause mode.

F Start the camcorder.

Engage the Play mode of the camcorder.

G Start the unit.

Press PLAY (4) to engage the Record mode of the unit.

NOTES:

Player

To EDIT

●Dubbing is also possible using the rear panel connectors.

●All necessary cables can be obtained from your dealer.

●When you select “EDIT” to dub tapes in step D, be sure to select “AUTO” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”) after you finish dubbing the tapes.