5

To connect the AM loop antenna cords

• Connect black cord to the H

terminal, and the while cord to
the other terminal.
•If the AM loop antenna wire or speaker cords are covered with
vinyl, remove the vinyl to expose the tip of the antenna by
twisting the vinyl.
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. Also, keep the
antennas away from metallic parts of the System, connecting
cords, and the AC power cord. This could cause poor
condition.

For better FM/AM reception

To connect the speaker cords

To connect other equipment

By using a stereo mini plug cord (not supplied), you can connect
equipment with analog audio output jacks such as an MD
player, a TV, etc.

If the audio output on the other equipment is not stereo

mini plug type,

use a plug adapter to convert the stereo mini
plug to the corresponding plug of the audio output.
• The supplied speakers do not conform to magnetically
shielded design. Place the speakers enough distance from
a TV so that they do not cause color irregularity on the TV.
• When connecting the speaker cords, match their polarity
with that of the speaker terminals: red/blue to (+) and black
to (–).
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
1 Hold
2 Insert
3 Release
Outdoor FM antenna
(not supplied)
Disconnect the supplied FM antenna, and
connect to an outdoor FM antenna using a 75 Ω
wire with coaxial type connector.
Vinyl-covered wire (not supplied)
When reception is poor, connect a single
vinyl-covered wire to the AM EXT terminal
and extend it horizontally.
AM loop antenna
Keep it connected.

• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom of
the speakers.

IMPORTANT

• Always set volume to VOL MIN when connecting or
disconnecting the other equipment.
DO NOT plug in any equipment until all
connections are complete.
Red
Black
From right
speaker
From left
speaker
1 Hold 2 Insert 3 Release
Blue
Black
(front panel)
Audio equipment
output
Stereo mini plug cord
(not supplied)

Do not connect the power cord until all other connections have been made.
HX-C6[J]-f.book Page 5 Monday, March 7, 2005 3:28 PM