JVC HX-GX7 manual To connect the speaker cords, To Connect Other Equipment, Outdoor FM antenna

To assemble and connect the AM loop antenna

To assemble the AM loop antenna

To connect the AM loop antenna cords

1 Hold 3 Release

2Insert

•If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl.

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. Also, keep the antennas away from metallic parts of the System, connecting cords, and the AC power cord. This could cause poor condition.

For better FM/AM reception

Outdoor FM antenna

(not supplied)

Disconnect the supplied FM antenna, and connect to an outdoor FM antenna using a 75 Ω wire with coaxial type connector.

		ANTENNA
		AM
	EXT	LOOP
AM
		75
		COAXIAL
		FM

AM loop antenna

Keep it connected.

Vinyl-covered wire (not supplied)

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it

To connect the speaker cords

•When connecting the speaker cords, match the polarity of the speaker terminals: (+) to (+) and (–) to (–).

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

•DO NOT connect more than one speaker to each terminal.

• DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

1 Hold	2 Insert		3 Release
Speaker			Speaker
cords			cords
(black/blue)			(black/blue)
		Speaker cords
From right speaker		(black/red)	From left speaker

To Connect Other Equipment

By using an stereo mini plug cord (not supplied), you can connect equipment with analog audio output jacks such as an MD player, a TV, etc.

Stereo mini plug cord (not supplied)

AUX

Audio equipment output

(front panel)

If the audio output on the other equipment is not stereo mini plug type, use a plug adapter to convert the stereo mini plug to the corresponding plug of the audio output.

IMPORTANT

•Always set volume to MIN when connecting or disconnecting the other equipment.

DO NOT plug in any equipment until all connections are complete.

5