KD-S52
Installation/Connection Manual
Manual de instalación/conexión
0805DTSMDTJEIN | |
[J] | EN, SP |
ENGLISH
You need the installation kits which corresponds to your car. | Check the battery system in your car. | |||||||||
• Mark all the check boxes ( |
| ) to make sure you have follow the instructions and the listed |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
parts. |
|
|
|
|
|
|
|
|
| 12 V DC, NEGATIVE ground |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
Parts list for installation and connection
A / B | C | D | E |
Hard case/Control panel | Sleeve | Trim plate | Power cord |
F | G | H | I | J | K | L | |
Remote controller | Battery | ||||||
Washer (ø5) | Lock nut (M5) | Mounting bolt— | Rubber cushion | Handles | |||
|
|
M5 x 20 mm (M5 x 13/16")
INSTALLATION (IN-DASH MOUNTING)
If you are not sure how to install this unit correctly, consult your JVC car audio dealer.
Do the required electrical connections.
Bend the appropriate tabs to hold the sleeve firmly in place.
Removing the unit
Before removing the unit, release the rear section.
ELECTRICAL CONNECTIONS
Make sure to disconnect the battery’s negative terminal.
•Be sure to ground this unit to the car’s chassis again after installation.
Note:
It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than
50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 19 of the INSTRUCTIONS).
High
Heat sink
When using the optional stay
Stay (option)
Fire wall
Dashboard
Screw (option)
When installing the unit without using the sleeve
In a Toyota for example, first remove the car radio and install the unit in its place.
Flat type screws—
M5 x 8 mm (M5 x 3/8")
Bracket
Bracket | Flat type screws— |
M5 x 8 mm (M5 x 3/8")
TROUBLESHOOTING
•The fuse blows.
* Are the red and black leads connected correctly?
•Power cannot be turned on. * Is the yellow lead connected?
•No sound from the speakers.
* Is the speaker output lead
•Sound is distorted.
*Is the speaker output lead grounded?
*Are the
•Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
•Unit becomes hot.
Install the unit at an angle of less than 30˚.
*Is the speaker output lead grounded?
*Are the
•This unit does not work at all. * Have you reset your unit?
1
