Troubleshooting, Bыявление Неисправностей

Connecting the leads / Пîäêëþ÷åíèå êîíòàêòîâ

PRECAUTIONS on power supply and speaker connections:

•DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged.

•Connect the black lead (ground), yellow lead (to car battery, constant 12 V), and red lead (to an accessory terminal) correctly.

•BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.

–If the speaker wiring in your car is as illustrated in Fig. 1 and Fig. 2 below, DO NOT connect the unit using that original speaker wiring. If you do, the unit will be seriously damaged. Redo the speaker wiring so that you can connect the unit to the speakers as illustrated in Fig. 3.

–If the speaker wiring in your car is as illustrated in Fig. 3, you can connect the unit using the original speaker wiring in your car.

–If you are not sure of the speaker wiring of your car, consult your car dealer.

ПРЕДОСТЕРЕЖЕНИЯ ïî ïèòàíèþ è ïîäêëþ÷åíèþ ãðîìêîãîâîðèòåëåé:

•НЕ ïîäêëþ÷àéòå ïðîâîäà ãðîìêîãîâîðèòåëåé ê àêêóìóëяòîðó àâòîìîáèëя, èíà÷å óñòðîéñòâî áóäåò ïîâðåæäåíî.

•Пðàâèëüíî ïîäêëþ÷èòå ÷åðíûé ïðîâîä (çåìëя), æåëòûé ïðîâîä (â àêêóìóëяòîð, ïîñòîяííûé 12 В) è êðàñíûé ïðîâîä (â âñïîìîãàòåëüíûé ðàçúåì).

•ПЕРЕД ïîäêëþ÷åíèåì ïðîâîäîâ ãðîìêîãîâîðèòåëåé ê êàáåëþ ïèòàíèя ãðîìêîãîâîðèòåëя ïðîâåðüòå ñõåìó ñîåäèíåíèé ãðîìêîãîâîðèòåëåé â Вàøåì àâòîìîáèëå.

–Еñëè ñîåäèíåíèя ãðîìêîãîâîðèòåëåé â Вàøåì àâòîìîáèëå ñîîòâåòñòâóåò èëëþñòðàöèè 1 è 2, НЕ ïîäêëþ÷àéòå óñòðîéñòâî ïðè ïîìîùè èñõîäíîãî êàáåëя ãðîìêîãîâîðèòåëåé. Еñëè Вû ýòî ñäåëàåòå, óñòðîéñòâî áóäåò ïîâðåæäåíî.

Пðèâåäèòå ñîåäèíåíèя ãðîìêîãîâîðèòåëåé â ñîîòâåòñòâèå ñ èçîáðàæåíèåì íà ðèñóíêå 3.

–Еñëè ñõåìà ñîåäèíåíèé ãðîìêîãîâîðèòåëåé â Вàøåì àâòîìîáèëå ñîîòâåòñòâóåò èëëþñòðàöèè 3, Вû ìîæåòå ïîäêëþ÷èòü óñòðîéñòâî, èñïîëüçóя èñõîäíóþ ñõåìó ñîåäèíåíèé ãðîìêîãîâîðèòåëåé â Вàøåì àâòîìîáèëå.

–Еñëè Вû íå çíàåòå ñîåäèíåíèå ãðîìêîãîâîðèòåëåé â Вàøåì àâòîìîáèëå, îáðàòèòåñü ê Вàøåìó àâòîìîáèëüíîìó äèëåðó.

+	+	+
L -	-	L -
+	+	+
R -	-	R -

-	+	+
	L -	-

-+ +

R - -

Fig. 1	Fig. 2	Fig. 3
Рèñóíîê 1	Рèñóíîê 2	Рèñóíîê 3

Connecting the leads / Пîäêëþ÷åíèå êîíòàêòîâ

CAUTION / ВНИМАНИЕ

Twist the core wires when connecting.

Solder the core wires to connect them securely.

•To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.

•Дëя ïðåäîòâðàùåíèя êîðîòêîãî çàìûêàíèя çàêëåéòå íåèñïîëüçóåìûå êîíöû èçîëèðóþùåé ëåíòîé.

Зàêðóòèòå êîíöû ïðîâîäîâ ïðè ñîåäèíåíèè.

Сïàяéòå ïðîâîäà äëя íàäåæíîãî ñîåäèíåíèя.

BConnections Adding Other Equipment / Пîäêëþ÷åíèå äðóãèõ óñòðîéñòâ

Amplifier / Уñèëèòåëü

You can connect an amplifier to upgrade your car stereo system.

•Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.

•For amplifier only:

–Connect this unit’s line-out terminals to the amplifier’s line-in terminals.

–Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused. (Cover the terminals of these unused leads with insulating tape, as illustrated above.)

Тàê êàê óñòðîéñòâî èìååò ëèíåéíûå âûõîäíûå ðàçúåìû, ê Вàøåé àâòîìîáèëüíîé ñòåðåî ñèñòåìå ìîæåò áûòü ïîäêëþ÷åí óñèëèòåëü è äðóãîå îáîðóäîâàíèå.

•Пîäêëþ÷èòå âíåøíèé ïðîâîä (ñèíèé ñ áåëîé ïîëîñîé) ê âíåøíåìó ïðîâîäó äðóãîãî óñòðîéñòâà äëя òîãî, ÷òîáû îñóùåñòâëяòü óïðàâëåíèå äîïîëíèòåëüíûì óñòðîéñòâî ïîñðåäñòâîì ýòîãî óñòðîéñòâà.

•Тîëüêî äëя óñèëèòåëя:

–Пîäêëþ÷èòå ëèíåéíûå âõîäû ýòîãî óñòðîéñòâà ê ëèíåéíûì âõîäàì óñèëèòåëя.

–Оòñîåäèíèòå ãðîìêîãîâîðèòåëè îò ýòîãî óñòðîéñòâà, ïîäêëþ÷èòå èõ ê óñèëèòåëþ. Оñòàâüòå ïðîâîäà ãðîìêîãîâîðèòåëåé íå ïîäñîåäèíåííûìè. (Зàêëåéòå íå èñïîëüçóåìûå êîíöû èçîëèðóþùåé ëåíòîé êàê ïîêàçàíî âûøå.)

	Rear speakers
Зàäíèå ãðîìêîãîâîðèòåëè
	INPUT	JVC Amplifier
L	L	JVC Amplifier
R	R	Уñèëèòåëü JVC
R	R

Signal cord (not supplied with this unit) Кàáåëü ñèãíàëà (íå âõîäèò â êîìïëåêò)

		CAUTION/ ПРЕДОСТЕРЕЖЕНИЕ
Remote lead	Y-connector (not supplied with this unit)	• To prevent internal heat buildup inside
Remote lead	Y-connector (not supplied with this unit)	this unit, place this unit UNDER the
Пðîâîä âíåøíåãî óñòðîéñòâà	Рàçúåì Y (íå âõîäèò â êîìïëåêò)	this unit, place this unit UNDER the
Пðîâîä âíåøíåãî óñòðîéñòâà	Рàçúåì Y (íå âõîäèò â êîìïëåêò)	other equipment.
		other equipment.
		• Дëя ïðåäîòâðàùåíèя ïåðåãðåâà
		ýòîãî óñòðîéñòâà ïîìåñòèòå ýòî
Remote lead (Blue with white stripe)		óñòðîéñòâî ПОД ïðî÷åå
Пðîâîä âíåøíåãî óñòðîéñòâà (ñèíèé ñ áåëîé ïîëîñîé)		îáîðóäîâàíèå.
	To power aerial if any
	To power aerial if any
	К ïèòàíèþ àíòåííû, åñëè åñòü

LINE OUT

L	L	KD-S717
	REAR FRONT	KD-S717

R R

Front speakers Пåðåäíèå ãðîìêîãîâîðèòåëè

TROUBLESHOOTING

BЫЯВЛЕНИЕ НЕИСПРАВНОСТЕЙ

•The fuse blows.

* Are the red and black leads connected correctly?

•Power cannot be turned on. * Is the yellow lead connected?

•No sound from the speakers.

* Is the speaker output lead short-circuited?

•Sound is distorted.

*Is the speaker output lead grounded?

*Are the “–” terminals of L and R speakers grounded in common?

•Unit becomes hot.

*Is the speaker output lead grounded?

*Are the “–” terminals of L and R speakers grounded in common?

•Сðàáîòàë ïðåäîõðàíèòåëü.

* Пðàâèëüíî ëè ïîäêëþ÷åíû ÷åðíûé è êðàñíûé ïðîâîäà?

•Пèòàíèå íå âêëþ÷àåòñя.

* Пîäêëþ÷åí ëè æåëòûé ïðîâîä?

•Зâóê íå âûâîäèòñя ÷åðåç ãðîìêîãîâîðèòåëè.

* Нåò ëè êîðîòêîãî çàìûêàíèя íà êàáåëå âûõîäà ãðîìêîãîâîðèòåëåé?

•Зâóê èñêàæåí.

*Зàçåìëåí ëè ïðîâîä âûõîäà ãðîìêîãîâîðèòåëåé?

*Зàçåìëåíû ëè ðàçúåìû “–” ëåâîãî (L) è ïðàâîãî (R) ãðîìêîãîâîðèòåëåé?

•Уñòðîéñòâî íàãðåâàåòñя.