Connection/Installation
Mounting the Camera
Setting Up the Wall
Be sure to put on protective glasses to protect your eyes from falling objects when mounting the camera.
1 Make holes in the wall
Make holes (R 45 mm) for the connecting cables to pass through.
Note:
●Check the strength of the wall. A less firm wall may cause the unit to fall.
2 Install the anchor bolts for mounting the camera
Install 4 anchor bolts (M8 35 mm and above) to mount the camera.
3 Install the anchor bolt for mounting the fall prevention wire
Install the anchor bolt (M8 35 mm and above) to mount the fall prevention wire 30 mm below the center of the upper two anchor bolts that are used to mount the camera.
152 |
|
|
126 |
|
|
63 |
|
|
12 | 30 |
|
| 176 | 213 |
60 |
|
|
| 20 |
|
3
Anchor bolt to |
| 2 | |
mount the fall |
| Anchor bolts to | |
prevention wire | 1 | ||
mount the camera | |||
| |||
|
|
4 Pull the cables from the hole in the wall
Pull the power cable, LAN cable and alarm signal cable from the wall.
LAN Cable
Power cable
Alarm signal cable
Setting Up the Camera
1 Remove the dome cover
Loosen the screws (x4) and remove the dome cover from the camera.
Dome Cover
2 Remove the cushioning material, lens cap and tape used during transporting
When installing the heater at an unrequired location, turn off the switch of the heater.
Tape
Cushioning material
Heater power switch
OFF
Lens cap
26