Mounting the Camera (continued)

Mounting the Camera

1Mount the fall prevention wire

●Mount the fall prevention wire of the camera to the fall prevention wire anchor bolt that was installed earlier.

●Secure the fall prevention wire tightly with a nut and washer.

2Pull out the cables (from the wall) from the cable connection hole.

3Mount the camera to the wall

●Mount the camera to the camera anchor bolts that were installed earlier.

●Secure the camera tightly with a nut and washer.

3 Washer

Nut

1

Fall Prevention

Wire2

Note:

●This product weighs approximately 5.5kg. When installing, pay extra attention as it may fall.

●For your safety, hold the arm section during installation.

●After installing, paint the nuts and washers to prevent corrosion.

Memo:

●To remove the camera, follow the reverse procedures.

Cable Connection

1 Connecting the power cable (A Page 30)

Connect the power cable and wind the waterproof tape (adhesive).

After connecting, push the cable into the arm of the camera.

Arm

Wind the waterproof tape (adhesive)

2 LAN Cable Connection (A Page 31)

AUse the provided RJ-45 conversion connector and connect the LAN cable.

BWind the connector section with waterproof tape (adhesive) and push the cable into the arm of the camera.

Arm

A

 

RJ-45

B

conversion

connector

 

Wind the

(provided)

 

waterproof tape

 

(adhesive)

 

28