3 Insert silica gel (when using PoE power supply)

Note:

●Be sure to insert the provided silica gel in the position as shown in the diagram when using the PoE power supply.Otherwise, the camera lens may fog up or the image may become blur.

ARemove the screw and lift up the plate

BTake out 3 silica gels from the aluminum bag and insert them into the position as shown in the diagram.

CFasten the screw

C

A

Plate

B

Silica gel 3

Memo:

●During reconnection or re-installation after repair or maintenance, make sure to replace the silica gel with a new one.

●Consult your nearby JVCfs dealer on the replacement procedures.Serial number of part to be replaced: Use a LW40500-001A silica gel.

Note:

●When mounting is performed on a rainy day,make sure that rain water does not enter this unit.

4 Mount the dome cover to the camera

Use the screws (x4) to mount the dome cover to the camera. As a guide, install the three catches of the dome cover and the central mark. Install such that the central mark appears above the JVC mark of the camera.

Position aligning catches (x3)

Face front

(towards direction of the JVC mark)

Note:

●Check that there is no dirt or dust inside the dome cover before mounting.

●When installing on a rainy day, ensure that raindrops do not enter the interior.

●When mounting the dome cover, temporarily secure the 4 screws and then tighten.

●As a guide, tighten the screws to 0.5 N•m to 1 N•m (5 kgf•cm to 10 kgf•cm). If the tightening is loose, the dome cover may fog due to water seepage.

5Remove the cable connection cap

Remove the cap on the arm of the camera.

6Pull out the cables from the cable connection hole

Pull out the cables (except the fall prevention wire) of the camera from the cable connection hole.

Cable connection cap

4

5

27