￿￿￿￿￿￿￿￿￿6RXUFH￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿79

￿',*,7$/

￿79

(;7￿￿

(;7￿￿

(;7￿￿￿6

(;7￿￿

(;7￿￿

(;7￿￿￿6

3&

Other Features

TV Status

Programme Number, Programme Name (or EXT), (they are displayed on the upper left of the screen). The sound indicator is displayed with them too. They are displayed after programme change for 3 seconds.

Sound Indicator

The alternatives of the indicator are Mono, Ste- reo, Dual I and Dual II. This indicator is displayed under the programme number indicator on the screen.

0RQR
In Mono broadcast or in forced-mono (for stereo broadcast).
6WHUHR
In Stereo broadcast.
'XDO￿,

If dual broadcast detected. Dual I is selected in default and also can be selected after Dual II by Remote Control.

'XDO￿,,
If Dual II selected by Remote Control.
Hyper Sound

By selecting Hyper Sound in sound menu or by pressing the “ ” button on your remote

control, Pseudo/Spatial effect can be turned on or off. In Mono transmission the left and right channels will be added at left channel and dummy stereo effect will introduced to end-user.

In stereo transmission it yields a phase difference between left and right channels.

Mute Indicator

It is placed in the upper middle of the screen when enabled, and it stays there until it is dis- abled.

To cancel mute, there are two alternatives; the

first one is by pressing the “” button, this volume is set to the preceding value, and the second one is increasing or decreasing the volume level.

No-Signal Detection (TV mode)

If no valid signal detected, it takes 5 minutes to switch to the Stand-By mode unless any signal detected or any Remote Control command is accessed.

After a Remote Control command (if No-Signal Timer is active) the timer stops and if no signal detected again the timer is initialized to 5 minutes and starts 3 seconds later again to count down.

It is not valid in EXT modes.
Volume Bar

It is displayed in the lower middle of the screen. When a volume command is received (press-

ing “ +” or “ -” by Remote Control or Control panel at the top of the TV) and no menu is active, it stays on the screen for 3 seconds, after the last volume command or until another command is received in between.

EXT Modes

By pressing the “AV” button you can switch your TV to EXT modes (except being in Tele- text). Pressing this button consecutively will switch the TV in one of the optional EXT modes: EXT-1, EXT-2, EXT-2 S, EXT-3, EXT-4, EXT-4 S, PC and DIGITALTV.

In order to quit the EXT mode press any digit
buttons or “” or “”

- 32 -