![](/images/new-backgrounds/1045467/454675x1.webp)
Assembly
English
5Assembling the satellite speakers
Each speaker (except the center speaker) has been divided into two parts for shipment. Before using this speaker system, assemble it first by following the procedure below.
• Prepare a Phillips screw driver.
Speaker | Stand |
section |
|
Before assembling—
•Take care not to drop the stand while assembling; otherwise, it may cause damage to the floor or injury.
•Ensure enough space for assembly and installation.
•Place a large, thick cloth on the floor where you assemble the speaker, so you can protect the floor and the speaker itself.
•Use the speaker only after assembly is fully and correctly done.
1Connect the speaker connecters to the stand connecters.
2 Join the stand to the speaker section.
Stand
Speaker section
3 Fix the stand to the speaker section.
• Be sure to tighten the screws firmly.
Speaker section | Stand |
|
Screw (4)
(Supplied, M4 x 25 mm)
Front
Speaker connectors
Front
Stand
Speaker section | Rear |
It is recommended to place a cushion under the speaker section.
•You can tighten the screws easily by placing the speaker section horizontally.
Cushion (not supplied)
To be continued on the next page
– 2 –