JVC LVT1047-001A manual Connection, Typical connection method to an amplifier, Before connecting

Connection

5Connecting the speaker system to the amplifier

Before connecting—

• Turn off the power to the amplifier before connecting the

speaker system; otherwise, the speakers may be damaged.

• The impedance of each speaker is 8 Ω. Before connecting

them to your amplifier, check the speaker impedance range

of your amplifier. If the impedance of this speaker is out of

the speaker impedance range indicated on the amplifier, you

cannot connect this system to the amplifier.

5Typical connection method to an amplifier

Connect the speakers to a “SPEAKER” terminal of the amplifier with the speaker cords by referring to the diagram below.

•Make sure to match the polarity (ª and ·) when connecting the speaker cords.

•The diagram below is an example of a typical connection method.

• The maximum power handling capacity of the SP-F303 is

100 W. Excessive input will result in abnormal noise and

possible damage.

• Be sure to turn down the volume level to prevent unwanted

noise before performing following operations:

– Turning on or off other components,

– Operating the amplifier,

– Tuning FM stations,

– Fast-forwarding a tape,

– Continuously reproducing high frequency oscillation or

high pitch electronic sounds.

• When using a microphone, do not aim it at the speakers or

use it near the speakers; otherwise, the howling which

occurs may damage the speakers.

• Before replacing the cartridge, always turn off the power to

the turntable; otherwise, the clicking noise may damage the

speakers.

Front right

Center speaker

(Approx. 5 m)
CENTER	SURROUND	FRONT
SPEAKER	SPEAKERS	SPEAKERS
	RIGHT LEFT	RIGHT LEFT
(Approx. 5 m)
Surround right

Speaker terminals

on the amplifier

Front left

(Approx. 5 m) Surround left

(Approx. 10 m) (Approx. 10 m)

– 5 –