JVC LVT1150-003B Setting up the wireless receiver unit, Example When the channel 4 is selected

Connections

Setting up the wireless receiver unit

1 Make sure that the CHANNEL SELECTOR is set to the 1 position.

CHANNEL SELECTOR

CAUTION

•DO NOT cover the front panel of the center unit with any metallic object, otherwise the radio wave cannot reach the wireless receiver unit.

•When you connect speakers other than the supplied ones, use speakers of the same speaker impedance (SPEAKER IMPEDANCE) indicated near the speaker terminals on the rear of the powered subwoofer.

•DO NOT connect more than one speaker to one speaker terminal.

•When installing the satellite speakers on the wall;

•Be sure to have them installed on the wall by a qualified personnel. DO NOT install the satellite speakers on the wall by yourself to avoid unexpected damage from their falling off the wall due to incorrect installation or weakness in wall structure.

•Care must be taken in selecting a location for speaker installation on a wall. Injury to personnel or damage to equipment may result if the speakers installed interfere with daily activities.

Wireless receiver unit

2 Fully extend the telescopic antenna upright.

•If necessary, turn the telescopic antenna until you have the best reception while hearing the sound of the surround speakers.

NOTE

•When other DVD digital cinema system or wireless device is nearby this system, interference or noise may result. In such a case, change the channel on both the center unit and the wireless receiver unit of this system.

Example: When the channel 4 is selected

CHANNEL SELECTOR

Wireless receiver unit

WR L S C H : 4

Center unit (See “WRLS CH” in “Sound and other settings” (A pg. 36).)

12