JVC SP-MXKC4, LVT1343-006A, 0205NYMCREBET manual Troubleshooting, Specification

Troubleshooting

•If you are having a problem with your System, check this list for a possible solution before calling for service.

•If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as your dealer, for service.

Symptom

Possible Cause Action

No sound is heard.

Poor radio reception

The disc tray does not open.

The CD skips.

The CD does not play.

The MP3 disc does not play.

The readout time of the MP3 disc is too long.

The cassette holder cannot be opened.

Unable to record.

Unable to operate the Remote Control.

Operations are disabled.

•Connections are incorrect, or loose.

•Headphones are connected.

•The antenna is disconnected.

•The AM Loop Antenna is too close to the Sys- tem.

•The FM Wire Antenna is not properly extended and positioned.

•The AC power cord is not plugged in.

•Tray is locked.

The CD is dirty or scratched.

The CD is upside down.

•No MP3 files are recorded on the disc.

•MP3 files do not have the file extension —

.MP3, .Mp3, .mP3, or .mp3 in thier file names.

•MP3 files are not recorded in the format com- pliant with ISO 9660 Level 1 or Level 2.

The readout time varies with the complexity of the recording configuration.

During tape playing, the power cord was unplugged.

Cassette record protect tabs are removed.

•The path between the Remote Control and the sensor on the Unit is blocked.

•The batteries have lost their charge.

The built-in microprocessor has malfunctioned due to external electrical interference.

•Check all connections and make corrections. (See pages 4 to 6.)

•Disconnect the headphones.

•Reconnect the antenna securely.

•Change the position and direction of the AM Loop Antenna.

•Extend FM Wire Antenna to the best reception position.

•Plug the AC power cord.

•Unlock the tray. (See page 15.)

Clean or replace the CD. (See page 25.)

Put the CD in with the label side up.

Replace the disc.

Do not use too many hierarchies and folders when recording. Also, do not record any other types of au- dio tracks together with MP3 files. (See page 11.)

Plug in the power cord, and turn on the System.

Cover holes on back edge of cassette with tape.

•Remove the obstruction.

•Replace the batteries.

Unplug the System then plug it back in.

Specification

Amplifier		Speaker Specifications (each unit)
Output Power	140 W per channel, min. RMS, driven	SP-MXKC4
	into 6 Ω at 1kHz, with no more than	Type	3-way bass-reflex type
	10% total harmonic distortion	Speaker Unit	Woofer:	16 cm cone × 1
	(IEC 268-3)		Mid:	5cm cone × 1
Input Sensitivity/Impedance (1 kHz)			Tweeter; 2cm dome × 1
AUX IN	400 mV/50 kΩ	Power Handling Capacity	140 W
Speaker terminals	6 Ω - 16 Ω	Impedance	6 Ω
Phones	32 Ω - 1 kΩ	Frequency Range	45 Hz - 22 000 Hz
Cassette Deck Section	15 mW/ch output into 32 Ω	Sound pressure level	87 dB/W·m
		Dimensions	266 mm × 333 mm × 241 mm (W/H/D)
Frequency Response		Mass	Approx. 3.9 kg
Type I (NORMAL)	63 Hz - 12 500 Hz	Accessories
Wow And Flutter	0.15% (WRMS)		AM Loop Antenna (1)
CD Player			Remote Control (1)
CD Capacity	3 CDs		Batteries R6P (SUM-3)/AA (15F) (2)
Dynamic Range	85 dB	Power Specifications	FM Wire Antenna (1)
Signal-To-Noise Ratio	85 dB
Wow And Flutter	Unmeasurable	Power Requirements	AC 240V	50Hz
Tuner		Power Consumption	140 W (power on mode)
FM Tuner			22 W (in Standby mode)
Tuning Range	87.50 MHz - 108.00 MHz
AM Tuner		Design and specifications are subject to change without notice.
Tuning Range	522 kHz - 1710 kHz
Unit
Dimensions	270 mm × 306 mm × 456 mm (W/H/D)
Mass	Approx. 8.6 kg

26