JVC LYT0002-0N4B specifications Remote sensor, Index Code Marking Interval Timer Indicator

Transmitted beam effective area

15° 5m(16.4ft)

30
°	30°
15°

Remote sensor

	EN 41
FEATURE:	Self-Timer, Animation and Time-Lapse
PURPOSE:	The remote control lets you set/release
	Interval Timer and Rec Time functions
	as well as the Menu screen.
OPERATION:	Self-Timer
	1) Set
	Instead of performing steps 1 through 3
	on pg. 30 (“Self-Timer”), press INT.
	TIME on the remote control. Each time
	INT. TIME is pressed, the Interval Timer
	indicator appears, changing in the
	following order: 15S, 30S, 1MIN, 5MIN
	and No indication (off).

When using the remote control, be sure to point it at the remote sensor. The above illustration shows the approximate transmitted beam effective area for indoor use.

The transmitted beam may not be effective or may cause incorrect operation outdoors or when the remote sensor is directly exposed to sunlight or powerful lighting.

Index Code Marking

Interval

Timer Indicator

1MIN INDEX 1/2S

Rec Time Indicator

LCD monitor or viewfinder

START/STOP

VISS

INT. TIME

REC TIME

RM-V704U or RM-V700U (provided)

	2) Release
	Instead of setting “INTERVAL TIMER” to
	“OFF” in the Menu, press INT. TIME on
	the remote control until the Interval
	Timer indicator disappears.
	Animation
	1) Set
	Instead of performing steps 1 and 2 on
	pg. 31 (“Animation”), press REC TIME
	on the remote control. Each time REC
	TIME is pressed, the Rec Time indicator
	appears, changing in the following
	order: 1/4S, 1/2S, 1S and No indication
	(off).
	2) Release
	Instead of using the Menu in step 5 on
	pg. 31, press REC TIME on the remote
	control until the Rec Time indicator
	disappears.
	Time-Lapse
	1) Set
	Instead of performing steps 1 through 3
	on pg. 31 (“Time-Lapse”), press INT.
	TIME and REC TIME on the remote
	control. Each time INT. TIME is
	pressed, the Interval Timer indicator
	appears, changing in the following
	order: 15S, 30S, 1MIN, 5MIN and No
	indication (off). Each time REC TIME is
	pressed, the Rec Time indicator
	appears, changing in the following
	order: 1/4S, 1/2S, 1S and No indication
	(off).
	2) Release
	Instead of using the Menu in step 5 on
	pg. 31, press INT. TIME and REC TIME
	on the remote control until the
	indicators disappear.
NOTE:	Also refer to pgs. 30 and 31.
FEATURE:	Index Code Marking
PURPOSE:	To give you automatic access to any
	selected point on a recording.
OPERATION:	1) Press VISS once to place the index
	code. “INDEX” blinks in the LCD
	monitor or the viewfinder during
	marking.
NOTE:	If VISS is pressed during Record–
	Standby mode, the mark is placed
	where START/STOP is pressed.