![](/images/new-backgrounds/1179300/17930085x1.webp)
EN 43
Display
Audio Dub Standby mode
6e
Speaker
Power Switch
Remote sensor
Stereo microphone
A.DUB
PAUSESTOP PLAY
Audio Dubbing
The audio track can be customized only when recorded in the
NOTES:
●Audio Dubbing is not possible on a tape recorded in 16- bit audio, on a tape recorded in the LP mode or on a blank portion of a tape.
●To perform Audio Dubbing while watching on the television, make connections ( pg. 20).
1 Play back the tape to locate the point where editing will start, then press PAUSE (6).
2 While holding A.DUB (e) on the remote control, press PAUSE (6). “6e” appears.
3 Press PLAY (4) , then begin “narrating”. Speak into the microphone.
•To pause dubbing, press PAUSE (6).
4 To end Audio Dubbing, press PAUSE (6), then STOP (5).
To hear the dubbed sound during playback . . .
..... set “12BIT MODE” to “SOUND 2” or “MIX” in the
Menu Screen ( pg. 36, 37).
NOTES:
●Sound is not heard from the speaker during Audio Dubbing.
●When editing onto a tape that was recorded at
●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.
●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.
●If you change from
●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in
audio or a blank portion, Audio Dubbing stops ( pg. 62).