JVC LYT0944-001A specifications 48 EN, For replacement

48 EN TROUBLESHOOTING

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the beginning.

1	SYMPTOM	POSSIBLE CAUSES	CORRECTIVE ACTION
2No power is supplied.		• The power is not connected	• Connect the AC Adapter securely
		properly.	( pg. 9).
		• The battery is dead.	• Replace the dead battery with a
			fully charged one ( pg. 8, 9).
	“SET DATE/TIME!”	• The date/time is not set.	• Set the date/time ( pg. 11).
3appears.		• The built-in clock battery has run	• Consult your nearest JVC dealer
		out and the previously set date/time	for replacement.
		has been erased.
	Recording cannot be	• The tape’s erase protection tab is	• Set the tape’s erase protection tab
4performed.		set to “SAVE”.	to “REC” ( pg. 12).
		• The Power Switch is set to “PLAY”	• Set the Power Switch to “ ” or
		or “OFF”.	“ ” ( pg. 16).
		• “TAPE END” appears.	• Replace with new cassette
		• The cassette holder cover is open.	( pg. 12).
			• Close the cassette holder cover.
5There is no picture.		• The camcorder is not getting	• Turn the camcorder’s power off
		power, or some other malfunction	and on again ( pg. 16).
		exists.
	The focus does not adjust	• Focus is set to the Manual mode.	• Set Focus to the Auto mode
6automatically.		• The recording was done in a dark	( pg. 29).
		place, or the contrast was low.	• Clean the lens and check the focus
		• The lens is dirty or covered with	again ( pg. 53).
		condensation.
	The cassette will not load	• The cassette is in the wrong	• Set it in the right position
7properly.		position.	( pg. 12).
		• The battery’s charge is low.	• Install a fully charged battery
			( pg. 8, 9).
	Snapshot mode cannot be	• The Squeeze mode is selected.	• Disengage the Squeeze mode
	used.		( pg. 34).