Attach the core filters to the cables. The core filter reduces interference.
Types of core filtersSize | Cable | Times to | |
wind | |||
|
| ||
|
|
| |
Large | DV cable* | Twice | |
|
|
| |
Small | Once | ||
| USB cable** |
| |
|
|
|
*Optional
(If you have an optional JVC DV cable
**
1 Release the stoppers on both ends of the core filter.
Power
Power Switch
POWER/CHARGE
lamp Lock Button
Battery pack mount
Arrow
To DC connector
Mark | Battery pack |
| BATT.RELEASE |
Stopper
2 Run the cable through the core filter, leaving approx. 3 cm of cable between the cable plug and the core filter. Wind the cable once around the outside of the core filter as shown in the illustration.
●Wind the cable so that it is not slack.
3 cm
AC Adapter
To AC outlet
This camcorder’s
Wind once.
3 Close the core filter until it clicks shut.
NOTES:
●Take care not to damage the cable.
●When connecting a cable, attach the end with the core filter to the camcorder.
1 With the arrow on the battery pack pointing upward, push the battery pack slightly against the battery pack mount a.
2
3 Set the Power Switch to “OFF (CHARGE)”.
4
5 Plug the AC Adapter into an AC outlet. The POWER/ CHARGE lamp on the camcorder blinks to indicate charging has started.
6 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.
To detach the battery packSlide the battery pack down slightly while sliding BATT. RELEASE to detach it.Battery pack | Charging time |
|
|
Approx. 1 hr. 30 min. | |
|
|
Approx. 3 hr. | |
|
|
Approx. 5 hr. | |
|
|
* Provided |
|
NOTES:
●If the protective cap is attached to the battery pack, remove it first.
●During charging, the camcorder cannot be operated.
●Charging is not possible if the wrong type of battery is used.