Turn on the video unit’s power.
Insert the source cassette in this camcorder. Insert the recording cassette in the video unit.

 

EDITING EN 35

Dubbing To Or From A Video Unit

NOTES:

● It is recommended to use the AC Adapter as the power

Equipped With A DV Connector (Digital

supply instead of the battery pack. ( pg. 7)

 

Dubbing)

● If the remote control is used when both the player and

recorder are JVC video units, both units will perform the

 

same operation. To prevent this from happening, press the

It is also possible to copy recorded scenes from the

buttons on both units. (GR-D93/73 only)

camcorder onto another video unit equipped with a DV

● If a blank portion or disturbed image is played back on the

connector. Since a digital signal is sent, there is little if

player during dubbing, the dubbing may stop so that an

any image or sound deterioration.

unusual image is not dubbed.

● Even though the DV cable is connected correctly,

 

 

sometimes the image may not appear in step 9. If this

 

occurs, turn off the power and make connections again.

 

● If “Playback Zoom” ( pg. 16) or “Playback Special Effects”

 

( pg. 16) is attempted (GR-D93/73 only) or SNAPSHOT

 

is pressed during playback, only the original playback

 

image recorded on the tape is output from the DV IN/OUT

 

connector.

 

● When using a DV cable, be sure to use the optional

 

JVC VC-VDV204U DV cable.

To DV IN/OUT

Core filter DV cable (optional)

To DV IN/OUT

Video unit equipped with DV connector

To use this camcorder as a recorder

1)Perform steps 1 to 4 in “To use this camcorder as a player”.

2)Set “REC MODE” to “SP” or “LP”. ( pg. 25, 26)

3)Insert the recording cassette in this camcorder.

4)Press the Recording Start/Stop Button to engage the Record-Pause mode.

● The “ DV. IN ” indication appears on the screen.

5)Press the Recording Start/Stop Button to start recording. The T indication rotates.

6)Press the Recording Start/Stop Button again to stop recording. The T indication stops rotating.

NOTES:

●If no image is displayed on the LCD monitor, set “S/AV INPUT” to “OFF”. ( pg. 25, 28) (GR-D93/73 only)

●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting. ( pg. 26)

To use this camcorder as a player

1 Make sure all units are turned off.

2 Connect this camcorder to a video unit equipped with a DV input connector using a DV cable as shown in the illustration.

3 Set this camcorder’s VIDEO/MEMORY Switch to “VIDEO”. (GR-D93/73 only)

4 Set this camcorder’s Power Switch to “PLAY” while pressing down the Lock Button located on the switch.

5

6

7

8 Press 4/9 on this camcorder to start playback of the source cassette.

9 At the point you want to start dubbing, engage the video unit’s Record mode.

10 To pause dubbing, engage the video unit’s Record- Pause mode and press 4/9 on this camcorder.

11 Repeat steps 8 – 10 for additional editing. Stop the video unit and camcorder.