![](/images/new-backgrounds/1200601/2006017x1.webp)
Procedure for Installing the MC-R433U in
the CD/DVD Library
Sensor slit
<MC-R433U insertion direction>
CONNECTION
●Connect the
If the
Also refer to the instruction manual for the CD/ DVD Library.
Procedure for Attaching the Provided
SCSI Cable
*If the provided SCSI cable is not used, go to "Procedure for Con- necting the Cables to the Back of the
Provided SCSI cable
Drive locking screw
1. Insert the
Be sure not to damage the sensor slit.
Make sure that the direction of the
Be sure that the cables connected to the rear of the CD/ DVD Library are not caught or pinched when inserting the
2.Insert the
3.Screw in the provided drive locking screw to the screw in- stallation hole of the drive locking section.
Tighten the screw firmly.
If the drive locking screw is loose, the drive and/or Li- brary may be damaged.
| SCSI connector |
Blind plate | mounting screw |
Connector cap
Drive storage cover
<Provided SCSI cable connection method>
1. In order to remove the two blind plates, remove the four screws from the SCSI connector installation section at the rear of the CD/DVD Library (drive storage cover).
2. Insert the provided SCSI cable through the installation hole from the inside of the drive storage cover and secure it with the four screws.
Remove the connector cap of the SCSI cable for instal- lation.
Be sure that the SCSI connector is inserted in the cor- rect direction. (It should be the same as the direction of the SCSI connector
3.If the cable or the terminator are not being connected to the OUT side of the SCSI connector
E