![](/images/new-backgrounds/1200601/20060111x1.webp)
SETUP (continued)
Procedure for Setting the Slide Switch
W N
W | N |
EXECUTION OF AUTO-
MATIC DRIVE DETEC-
TION MODE.
●Execute the automatic drive detection mode of the CD/DVD Library.
For the automatic drive detection mode, refer to the instruction manual for the CD/DVD Library.
CAUTION
Be sure to close the drive storage cover and door of the CD/DVD Library before turning it on.
After installing, adding, replacing or removing the drives, be sure to execute the automatic drive detection mode. Otherwise, a malfunction may result.
After installing, adding, removing or replacing the drives, or changing the SCSI ID No., be sure to turn the host computer off and then turn it on again.
<Slide switch position on the
1. Ensure that the slide switch is set to N.
The W position is for use by service personnel only. The user should not use this position.
Procedure for Attaching the Drive Storage Cover of the CD/DVD Library
1. Secure the cover with the screws that were removed. "Procedure for Opening the Drive Storage Cover of
the CD/DVD Library" on page 3.
Procedure for Executing the Automatic Drive Detection Mode of the CD/DVD
1. While holding the "8" key on the control panel, turn the power of the CD/DVD Library on.
2. When the LCD shows "DRIVE DETECTION COMPLETED," turn the power of the CD/DVD Library off.
3. Turn the CD/DVD Library on again.
The DRIVE DISPLAY of the CD/DVD Library displays this drive as a
Procedure for Closing the CD/DVD
Library Door
1. Close the door and lock the key cylinder.
Procedure for Connecting the CD/DVD
Library to the Host Computer
When using an external SCSI cable, use a
<Clamp filter attachment method 1>
Tighten until the tabs
are locked completely.
E