JVC MX-DK15 manual ¤Surround speakers for CA-MXDK5and MX-DK3, #Main speakers

For the Australian model

Stereo mini plug

(not supplied)

@Subwoofers (for CA-MXDK5 and MX-DK3)

•MX-DK3 has only one subwoofer.

•When connecting the speaker cords, match the polarity of the speaker terminals: (+) to (+) and (–) to (–).

CA-MXDK5

¤Surround speakers (for CA-MXDK5 and MX-DK3)

From right surround speaker (not supplied)

From left surround speaker (not supplied)

•The surround speakers connected can reproduce the bass sounds recorded in front left and right channels, but cannot reproduce the surround signals recorded in DVD multi- channel discs.

#Main speakers

•When connecting the speaker cords, match the polarity of the speaker terminals: (+) to (+) and (–) to (–).

From right	From left
subwoofer	subwoofer

MX-DK3

From the subwoofer

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

From right	From left
main speaker	main speaker

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

•The speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers.

–When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers.

Then wait at least 30 minutes before turning on the TV’s main power switch again.

Some TVs may still be affected even though you have followed the above. If this happens, move the speakers away from the TV.

•DO NOT connect more than one speaker to each terminal.

• DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

5