JVC MX-GT90 manual Connecting Other Equipment, Canceling the display demonstration, terminal

Models: MX-GT90

1 34
Download 34 pages 29.81 Kb
Page 11
Image 11
2Insert the end of the speaker cord into the

1Open the speaker terminals on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity (colors) of the speaker terminals: Red

To connect audio equipment with an optical digital input terminal

You can record CD sound onto the connected digital equipment.

(+)to red (+) and black (–) to black (–); Blue (+) to blue

(+)and black (–) to black (–).

3Close the speaker terminals.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

Connecting Other Equipment

CD OPTICAL

DIGITAL OUTPUT

Protective plug

Before connecting the other equipment, remove the protective plug from the terminal.

You can connect both analog and digital equipment.

• DO NOT connect any equipment while the power terminal.3Close the speaker terminals.Connecting Other Equipment is on.

DO NOT plug in any equipment until all connections are complete.

Audio equipment with an optical digital input

To optical digital input

Connect an optical digital cord (not supplied) between the optical digital input terminal on the other equipment and the CD OPTICAL DIGITAL OUTPUT terminal.

To connect an analog component

Be sure that the plugs of the audio cords are colored: White plugs and jacks are for left audio signals, and red ones for right audio signals.

Audio equipment

To audio output

For playing the other equipment through this unit,

connect between the audio output jacks on the other equipment and AUX jacks by using audio cords (not supplied).

Now, you can plug the AC power cord.

When connecting the AC power cord into a wall outlet, the unit automatically starts display demonstration.

IMPORTANT: Be sure to check all connections to be done before plugging the AC power cord into a wall outlet.

Canceling the display demonstration

On the unit ONLY:

To cancel the display demonstration, press

CANCEL/DEMO until “DEMO OFF” appears on the display.

When you press other buttons

The display demonstration stops temporarily. It will start automatically again (if no operation is done for 2 minutes) until you cancel it by pressing CANCEL/DEMO.

To start the display demonstration manually

Press and hold CANCEL/DEMO again for more than 1 second.

– 8 –

Page 11
Image 11
JVC MX-GT90 Connecting Other Equipment, Canceling the display demonstration, 2Insert the end of the speaker cord into the