Troubleshooting

•If you are having a problem with your System, check this list for a possible solution before calling for service.

•If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as your dealer, for service.

English

Symptom

No sound is heard.

Poor radio reception

The disc tray does not open.

The CD skips.

The CD does not play.

The MP3 disc does not play.

The readout time of the MP3 disc is too long.

The cassette holder cannot be opened.

Unable to record.

Unable to operate the Remote Control.

Operations are disabled.

Possible Cause

•Connections are incorrect, or loose.

•Headphones are connected.

•The antenna is disconnected.

•The AM Loop Antenna is too close to the System.

•The FM Wire Antenna is not properly extended and positioned.

•The AC power cord is not plugged in.

•Tray is locked.

The CD is dirty or scratched.

The CD is upside down.

•No MP3 files are recorded on the disc.

•MP3 files do not have the file extension —

.MP3, .Mp3, .mP3, or .mp3 in thier file names.

•MP3 files are not recorded in the format compliant with ISO 9660 Level 1 or Level 2.

The readout time varies with the complexity of the recording configuration.

During tape playing, the power cord was un- plugged.

Cassette record protect tabs are removed.

•The path between the Remote Control and the sensor on the Unit is blocked.

•The batteries have lost their charge.

The built-in microprocessor has malfunctioned due to external electrical interference.

Action

•Check all connections and make corrections. (See pages 4 to 6.)

•Disconnect the headphones.

•Reconnect the antenna securely.

•Change the position and direction of the AM Loop Antenna.

•Extend FM Wire Antenna to the best recep- tion position.

•Plug the AC power cord.

•Unlock the tray. (See page 15.)

Clean or replace the CD. (See page 25.)

Put the CD in with the label side up.

Replace the disc.

Do not use too many hierarchies and folders when recording. Also, do not record any other types of audio tracks together with MP3 files. (See page 11.)

Plug in the power cord, and turn on the System.

Cover holes on back edge of cassette with tape.

•Remove the obstruction.

•Replace the batteries.

Unplug the System then plug it back in.

Specification

Amplifier

 

Speaker Specifications (each unit)

 

Output Power

180 W per channel, min. RMS, driven

SP-MXKB4

 

 

 

into 6 Ω at 1kHz, with no more than

Type

3-way bass-reflex type

 

10% total harmonic distortion

Speaker Unit

Woofer:

20 cm (7-7/8") cone × 1

Input Sensitivity/Impedance (1 kHz)

 

Mid:

5cm (2") cone × 1

AUX IN

400 mV/50 kΩ

 

Tweeter:

2 cm (13/16") dome × 1

Speaker terminals

6 - 16 Ω

Power Handling Capacity

180 W

 

Phones

32 Ω - 1 kΩ

Impedance

6 Ω

 

Cassette Deck Section

15 mW/ch output into 32 Ω

Frequency Range

45 Hz - 22 000 Hz

 

Sound pressure level

87 dB/W·m

Frequency Response

 

Dimensions

257 mm × 321 mm × 261 mm (W/H/D)

Type I (NORMAL)

63 Hz - 12 500 Hz

 

(10-1/8" × 12-11/16" × 10-5/16")

Wow And Flutter

0.15% (WRMS)

Mass

Approx. 4.9 kg (10.9 lbs)

CD Player

 

Accessories

 

 

CD Capacity

3 CDs

 

AM Loop Antenna (1)

Dynamic Range

85 dB

 

Remote Control (1)

Signal-To-Noise Ratio

85 dB

 

Batteries R6P (SUM-3)/AA (15F) (2)

Wow And Flutter

Unmeasurable

Power Specifications

FM Wire Antenna (1)

Tuner

 

 

 

FM Tuner

 

Power Requirements

AC 120 V

, 60 Hz

Tuning Range

87.5 MHz - 108.0 MHz

Power Consumption

150 W (power on mode)

AM Tuner

 

 

22 W (in Standby mode)

Tuning Range

530 kHz - 1 710 kHz

 

 

 

Unit

270 mm × 306 mm × 456mm (W/H/D)

Design and specifications are subject to change without notice.

Dimensions

 

 

 

 

(10-11/16" × 12-1/16" × 18")

 

 

 

Mass

Approx. 8.6 kg (19.0 lbs)

 

 

 

26