RD-MD5(B)-e.fm Page 8 Wednesday, December 2, 1998 11:40 AM

Presetting Stations

Presetting Stations

You can preset up to 30 FM stations and up to 15 AM (MW/LW) stations.

Note: Preset numbers may have been set to factory test frequen- cies prior to shipment. This is not a malfunction. You can preset the stations you want into memory by following one of the presetting methods below.

Manual Presetting —————————

STORED

or

When changing the Band

FM=30,AM=15

1. Select a band by pressing the TUNER

BAND button.

2. Press the 4 or ¢ button to tune in a sta- tion.

3. Press the SET button.

The youngest blank preset number will blink. "P 1" will blink for the first time.

4. Turn the JOG dial to the right or left to select the preset number.

5. Press the SET button.

"STORED" appears and, after 2 seconds, the display returns to the broadcast frequency display.

6. Repeat above steps 1 to 5 for each station you want to store in memory with a preset number.

To cancel the presetting, press the CANCEL button in step 3 or 4.

To change the preset stations, repeat the same steps as above.

Auto Presetting ——————————

In each band, you can automatically preset FM-30, AM (MW/LW)- 15 stations. Preset numbers will be allocated as stations are found, starting from the lowest station and moving up the frequency.

or

(for 2 seconds)

or

 

1. Select a band by pressing the TUNER

BAND button.

2. Press the AUTO PRESET button on the

Remote Control for more than two sec- onds.

3. Repeat steps 1-2 for the other band.

If you want to change the preset stations, carry out the Manual Presetting for the desired preset numbers.

CAUTION: If the System is unplugged or if a pow- er failure occurs, the preset stations will be erased after about 24 hours. If this happens, you will need to preset the stations again.

To Change the FM

Reception Mode

When you are tuned in an FM broadcast, the "STEREO" indicator lights up and you can hear stereo effects.

If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose any stereo effect.

Press the FM MODE button on the Remote Control so that the "MONO" indicator lights up on the display.

"MONO" indicator goes out. "MONO" indicator lights.

To restore the stereo effect, press the FM MODE button on the Remote Control so the "MONO" indicator goes off.

If you select other FM station, the “MONO” indicator goes out.

8

Page 11
Image 11
JVC manual Presetting Stations, To Change the FM Reception Mode, RD-MD5B-e.fm Page 8 Wednesday, December 2, 1998 1140 AM