JVC RV-B550 BU/RD Presetting the desired stations (using the remote control unit), 1 2 3 4, Preset station tuning (Receiving the preset stations), 1 2 3

MHz

SLEEP

PROGRAM

RANDOM

REPEAT

AUTO

PRESET

DISPLAY

REVERSE MODE

MULTI CONTROL

REW FF

TAPE

TUNER

BAND

FM MODE

C D

DOWN UP SET

AUX

SOUND ACS

Presetting the desired stations (using the remote control unit)

30 stations in the FM band and 15 stations in the AM (MW/LW) band can

be preset as follows:

÷Example: (Presetting an FM station broadcasting at 103.5 MHz to preset

button “15”)

1Press the TUNER BAND/FM MODE button.

2Select the FM band using the TUNER BAND/FM MODE button.

3Tune to the required station.

4Press preset button “+10”, then “5” for more than 2 sec.

(When “15” blinks in the preset station display, the station has been

stored.)

÷Repeat the previous procedure for each of the other stations, using a

different preset button each time.

÷Repeat the previous procedure for the other band.

÷To change preset stations

Perform step 4 after tuning to the required station.

Notes:

÷The previously stored station is erased when a new station is stored,

because the new station’s frequency replaces the previous frequency

in memory.

÷When listening to an AM (MW/LW) broadcast, noise may be heard if

the remote control unit is used.

To prevent the preset stations from being erased because of a power

failure, etc., install memory back-up batteries in the unit (see page 6).

Preset station tuning(Receiving the preset stations)

÷The stations must be preset before this operation can be performed.

(Using the main unit)

1Press the TUNER BAND button.

2Select the band using the TUNER BAND button.

3Each time the PRESET TUNING button is pressed, the next preset

station is selected.

(Using the remote control unit)

1Press the TUNER BAND/FM MODE button.

2Select the band using the TUNER BAND/FM MODE button.

3Press the required preset station buttons (No. 1 – No. 10 and +10).

÷The preset station number and frequency corresponding to the button

pressed are shown.

FM: Adjust the telescopic antenna’s length, angle and

direction until optimum reception is received.

AM (MW/LW): Install the unit where suitable reception is possible (beside

a window, etc.) or change the direction of the unit.

Note:

The built-in ferrite core antenna can pick up interference from television

receivers in the neighborhood and thereby disturb AM (MW/LW) reception.

Using the antennas

AM (MW/LW)