JVC RX-558RBK manual Activating the DSP Modes, English

DOLBY SURROUND

DOLBY SURROUND

English

On the front panel:

You can also use the buttons on the front panel to adjust the Surround modes. However, no test tone is available when using the buttons on the front panel. So, make adjustments while listening to the sound of the source played back.

1. Press SURROUND repeatedly	SURROUND
until the mode — “PROLOGIC,”
“3 STEREO,” or “THEATER”—
appears on the display.

The PRO LOGIC indicator also lights up on the display.

2. Press ADJUST so that the cursor	ADJUST
control % / Þ/ @/ #buttons work
for adjusting the DSP setting.

3. Press cursor control %/ Þ repeatedly until “–CENTER+ ” appears on the display.

4.Press cursor control @/ #to adjust the center speaker output

level (from –10 to +10).

5. Press cursor control %/ Þ repeatedly until “– REAR +” appears on the display.

8. ONLY FOR “THEATER”:

Press cursor control @/ #to select an effect level you want.

• Each time you press the button, the effect level changes as follows:

EFFECT 1 EFFECT 2 EFFECT 3

EFFECT 5 EFFECT 4

As the number increases, JVC Theater Surround becomes stronger.

Activating the DSP Modes

Once you have finished adjustments for the DSP modes, you can use the same adjustments every time you want to use these modes.

On the front panel:

1. Press SURROUND repeatedly	SURROUND
until the DSP mode you want
appears on the display.

•Each time you press the button, the DSP modes change. (See page 18 for more details.)

2.Select and play a sound source.

•To enjoy the 3D-PHONIC, Dolby Surround, and JVC Theater Surround, play back a software which was processed with

Dolby Surround and is labeled with mark.

To cancel the DSP mode

Press SURROUND repeatedly until “OFF” appears on the display.

6.Press cursor control @/ #to adjust the rear speaker output

level (from –10 to +10).

Note:

You cannot adjust the left and right rear speaker output levels separately.

7. ONLY FOR “THEATER”:

From the remote control:

1. Press SOUND CONTROL.

The 10 keys are activated for sound adjustments.

2.Press SURROUND repeatedly until the DSP mode you want appears on the display.

•Each time you press the button, the DSP modes change. (See page 18 for more details.)

SOUND

CONTROL

SURROUND

3

Press cursor control %/ Þ repeatedly until “–EFFECT+” appears on the display.

3. Select and play a sound source.

•To enjoy the 3D-PHONIC, Dolby Surround, and JVC Theater Surround, play back a software which was processed with

Dolby Surround and is labeled with mark.

To cancel the DSP mode

Press SURROUND repeatedly until “OFF” appears on the display in step 2 above.

21