AM (MW/LW) Antenna Connections
|
|
|
| Snap the tabs on the loop into the |
ANTENNA |
| slots of the base to assemble the | ||
|
| FM 75 | ||
|
| AM (MW/LW) loop. | ||
|
| COAXIAL | ||
|
|
|
|
|
|
|
|
|
|
Basic connecting procedure
1 | 2 | 3 |
|
|
|
AM
LOOP
1
AM | AM (MW/LW) Loop Antenna |
EXT |
|
23
1Cut, twist and remove the insulation at the end of each speaker signal cable (not supplied).
2Open the terminal and then insert the speaker signal cable.
3Close the terminal.
Connecting the front speakers
Connect front speakers to the FRONT SPEAKERS terminals.
Outdoor single
Turn the loop until you have the best reception.
Notes:
• If the AM (MW/LW) loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.
•Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord. This could cause poor reception.
•If reception is poor, connect an outdoor single
Connecting the Speakers
You can connect the following speakers:
•One pair of front speakers to produce normal stereo sound.
•One pair of rear speakers to enjoy the surround effect.
•One center speaker to produce more effective surround effect (to emphasize human voices).
•One subwoofer to enhance the bass.
IMPORTANT:
After connecting the speakers listed above, set the speaker setting information properly to obtain the best possible DSP effect. For details, see page 12.
For each speaker (except for a subwoofer), connect the (+) and
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
| FRONT | |
| SPEAKERS | |
| RIGHT | LEFT |
Left speaker | Right speaker |
|
Connecting the rear and center speakers
Connect rear speakers to the REAR SPEAKERS terminals and a center speaker to the CENTER SPEAKER terminals.
| CENTER | REAR | |
| SPEAKER | SPEAKERS | |
Center speaker | RIGHT | LEFT | |
|
| ||
Left rear | Right rear |
|
|
speaker | speaker |
|
|
4
