JVC RX-D205S manual Connecting the power cord, The USB drivers are installed automatically, Notes

5.The USB drivers are installed automatically.

•If the USB drivers are not installed automatically, install the USB drivers by following the instructions on the PC’s monitor.

6.Check if the drivers are correctly installed.

1. Open the Control Panel on your PC: Select [Start] = [Control Panel].

2. Select [System] = [Hardware] = [Device Manager] = [Sound, video and game controllers] and [Universal Serial Bus controllers].

•The following window appears, and you can check whether the drivers are installed.

NOTES

•DO NOT turn off the receiver or disconnect the USB cable while installing the drivers and for several seconds while your PC is recognizing the receiver.

•If your PC does not recognize the receiver, disconnect the USB cable and connect it again. If it does not work yet, restart Windows.

•The installed drivers can be recognized only when the USB cable is connected between the receiver and your PC.

•The sound may not be played back correctly—interrupted or degraded—due to your PC settings and PC specifications.

•Use a USB cable (version 1.1 or later). Recommended cord length is 1.5 m.

*Microsoft®, Windows® 98 SE, Windows® Me, Windows® 2000, and Windows® XP are registered trademarks of Microsoft corporation.

Connecting the power cord

When all the audio/video connections have been made, connect the AC power plug to the wall outlet. Make sure that the plugs are inserted firmly. The standby lamp lights in red.

CAUTIONS:

•Do not touch the power cord with wet hands.

•Do not alter, twist or pull the power cord, or put anything heavy on it, which may cause fire, electric shock, or other accidents.

•If the cord is damaged, consult a dealer and have the power cord replaced with a new one.

Now the PC is ready for playback through the USB connection.

After installation is completed, you can use your PC as the playback source. The PC automatically recognizes the receiver whenever a USB cable is connected between the PC and the receiver while the receiver is turned on.

•When not using the PC as the playback source, disconnect the USB cable.

To play back sounds on the PC, refer to the manuals supplied with the sound reproduction application installed in the PC. Start the application after the USB device is recognized.

If no sound comes from the speakers, check the following items:

–check if the USB device is recognized properly.

–check if the playback software in your PC is compatible with the USB device.

–open the Control Panel on your PC, select [Sounds and Audio Devices] = [Audio] tab = [Sound playback] = [Default device], and check if [Default device] is set to [USB Audio DAC].

–select “USB” as the source.

–connect the USB cable correctly.

NOTES

•Keep the power cord away from the connecting cables and the antenna. The power cord may cause noise or screen interference.

•The preset settings such as preset channels and sound adjustment may be erased in a few days in the following cases:

–When you unplug the power cord.

–When a power failure occurs.

•When you unplug the power cord with the receiver on and connect the power cord again, the receiver enters standby mode.

11