JVC RX-D211S, RX-D212B To tune in a preset channel, Messages on the display, Changing the channel information, NOTES, Message, Solution, 1Press XM, Press DISPLAY, Possible cause

4Press MEMORY again while the selected preset number is flashing on the display.

5Repeat steps 1 to 4 until you store all the desired channels.To erase a stored preset channel

Storing a new channel on a used preset number erases the previously stored one.

To tune in a preset channel

From the remote control:

1Press XM.

The last received channel is tuned in.

2Press the numeric buttons (0 – 9, h10) to select a preset channel number.

•For preset number 5, press 5.

•For preset number 10, press h10, 1, then 0.

•For preset number 15, press h10, 1, then 5.

On the front panel:

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

1Turn SOURCE SELECTOR to select “XM.”

The last received channel is tuned in.

2Press TUNER PRESET.

“P” flashes on the display, and MULTI JOG now works for selecting preset channels.

Changing the channel information

While listening to XM Satellite Radio, the currently selected channel information appears on the display.

You can change the kind of channel information.

From the remote control ONLY:

Press DISPLAY.

Each time you press the button, the channel information changes as follows:

CHAN (channel name)* = NAME (artist name/feature) = TITLE (song/program title) = CAT (category name) = Back to the beginning

* “CHAN” is the initial setting.

EX.: When the category name is selected:

DIGITAL AUTO L R

LINEAR PCM S.WFR

After one second

DIGITAL AUTO L R

LINEAR PCM S.WFR

NOTES

•If you turn off the power or select another source, the display is changed back to the initial setting.

•When you tune in to another channel, the channel name appears on the display and then the channel information you have selected appears.

•When all the text information cannot be shown on the display at the same time, the text scrolls.

•Some characters cannot be displayed correctly.

3Turn MULTI JOG to select a preset number.

•To increase the preset numbers, turn MULTI JOG clockwise.

•To decrease the preset numbers, turn MULTI JOG counterclockwise.

Messages on the display

When problems occur, a message appears on the display. In this case, refer to the following solution.

Message	Possible cause	Solution
NO SIGNAL	Signals are too weak.	Move the XM Passport Home Dock antenna near
		a south-facing window or where “Channel 1” can
		be heard clearly.

CHECK ANTENNA	The XM Passport Home Dock
	antenna is not connected properly.

Check the connection (see page 5).

LOADING	This receiver is loading the channel	It takes a few minutes to complete. Wait until
	information and audio data.	loading is finished.
OFF AIR	Selected channel is not currently	Select another channel.
	broadcasting any signal.
UPDATING	The latest encryption code is being	Wait until updating is finished.
	updated.

•Channel number and “-----”

•Preset number, channel number, and “-----”

No text information for the selected channel is available.

• Channel number and “CH---”		Selected channel does not exist or
• Preset number and “--->CH---	”	is not subscribed yet.

19