Connecting the speakers

Do not connect the AC power cord until all other connections have been made.

7 Speaker Layout Diagram

 

 

 

 

Powered

 

 

 

 

 

SW

subwoofer (SW)

 

 

 

 

 

 

Left surround back

Center speaker (C)

 

 

 

 

 

speaker (SBL)*

 

 

 

 

 

 

 

FL

C

 

FR

Right surround

 

 

 

back speaker (SBR)

 

 

 

 

 

 

 

 

SL

 

 

SR

 

 

 

 

 

 

 

Right surround speaker (SR)

Right front

 

 

 

 

 

Left surround speaker (SL)

Left front

SBL

(SB*)

SBR

 

speaker (R)

 

 

 

speaker

 

 

 

 

 

 

(L)

CAUTIONS:

•Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals (6 Ω – 16 Ω).

•DO NOT connect more than one speaker to one speaker terminal.

7 Connecting the speakers

Turn off all components before making connections.

To connect the center speaker and the front speakers

1 2 3 4

1Cut, twist and remove the insulation at the end of each speaker cord.

2Turn the knob counterclockwise.

3Insert the speaker cord.

•For each speaker, connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers.

4Turn the knob clockwise.

To connect the surround speakers and the surround back speakers

1

2

3

 

 

 

1Cut, twist and remove the insulation at the end of each speaker cord.

2Open the terminal (1), then insert the speaker cord (2).

•For each speaker, connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers.

3Close the terminal.

*When using a single speaker for the surround back speaker

You can enjoy the surround sound by one surround back speaker. When using one surround back speaker,

–set “S BACK OUT” to “1SPK” (see page 31) and

–connect the surround back speaker to the left surround back speaker terminal. (No sound comes from the speaker if you connect it to the right surround back speaker terminal.)

7 Connecting the powered subwoofer

By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in digital software.

Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cord with RCA pin plugs (not supplied).

• Refer also to the manual supplied with your subwoofer.

After connecting all the speakers and/or subwoofer, perform Precise Surround Setup to adjust the speaker settings automatically (see pages 16 to 19).

NOTE

You can place a subwoofer wherever you like since bass sound is non- directional. Normally place it in front of you.

8