4Press MEMORY again while the selected preset number is flashing on the display.
5Repeat steps 1 to 4 until you store all the desired channels.
To erase a stored preset channel
Storing a new channel on a used preset number erases the previously stored one.
7 To tune in a preset channel
From the remote control:
1Press XM.
The last received channel is tuned in.
2Press the numeric buttons (0 – 9, h10) to select a preset channel number.
•For preset number 5, press 5.
•For preset number 10, press h10, 1, then 0.
•For preset number 25, press h10, 2, then 5.
While listening to the XM Satellite Radio, the currently selected channel information appears on the display. You can change the type of channel information.
From the remote control ONLY:
Press DISPLAY.
Each time you press the button, the channel information changes as follows:
CHAN (channel name)* = NAME (artist name/feature) = TITLE (song/program title) = CAT (category name) = (Back to the beginning)
* CHAN (channel name) is the initial setting.
EX.: When the category name is selected:
After 1 second
On the front panel:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.
1Turn SOURCE SELECTOR to select “XM.”
The last received channel is tuned in.
2Press TUNER PRESET.
“P” flashes on the display, and MULTI JOG now works for selecting preset channels.
NOTES
•If you turn off the power or select another source, the display is changed back to the initial setting.
•When you tune in to another channel, the channel name appears on the display and then the channel information you have selected appears.
•When all the text information cannot be shown on the display at a time, the text scrolls.
•Some characters cannot be displayed correctly.
3Turn MULTI JOG to select a preset number.
•To increase the preset numbers, turn MULTI JOG clockwise.
•To decrease the preset numbers, turn MULTI JOG counterclockwise.
7 Messages on the display
When problems occur, a message appears on the display. In this case, refer to the following solution.
Message | Possible cause | Solution |
NO SIGNAL | Signals are too weak. | Move the XM Passport Home Dock antenna |
|
| near a |
|
| “Channel 1” can be heard clearly. |
|
|
|
CHECK ANTENNA | The XM Passport Home Dock antenna is |
| not connected properly. |
Check the connection (see page 7).
LOADING | This receiver is loading the channel | It takes a few minutes to complete. Wait until |
| information and audio data. | loading is finished. |
|
|
|
OFF AIR | Selected channel is not currently | Select another channel. |
| broadcasting any signal. |
|
|
|
|
UPDATING | The latest encryption code is being |
| updated. |
Wait until updating is finished.
• | Channel number and “ |
| No text information for the selected |
| ||
• | Preset number, channel |
| channel is available. | — | ||
| number, and |
|
|
|
| |
|
|
|
|
| ||
• | Channel number and | ” | Selected channel does not exist or is not | — | ||
• | Preset number and | ” | subscribed yet. | |||
| ||||||
|
|
|
|
|
| |
28