Advanced operations

See page 24 for button locations.

Sound and other settings

IMPORTANT

Before using the remote control for the following operation;

• Set the remote control mode selector to

AUDIO.

NOTE

Before you start operation;

•There is a time limit when doing the following steps. If the setting is cancelled before you finish, start from step 1 again.

1 Press SETTING.

Example:

B A L : C E N T E R

2 Press Cursor Y/5 to select the item you want to set.

•BAL (Balance):

You can adjust the balance between the front left and front right speakers.

•DEC (Decode):

When you play an external source (AUX DIGITAL is selected as a source) that was encoded with Dolby Digital or DTS Digital Surround, the following symptoms may occur;

•No sound comes out at the beginning of playback.

•Noise comes out while searching for or skipping chapters or tracks.

AUT/PCM (Auto/PCM):

Normally select this. The system automatically detects the incoming signals.

DOLBY D: Select this if the symptoms above occur when playing a disc (or software) encoded with Dolby Digital.

DTS: Select this if the symptoms above occur when playing a disc (or software) encoded with DTS Digital Surround.

3 Press Cursor 3/2 to make an adjustment or selection.

Example:

B A L : R -- 5

The adjustment is set and the display automatically disappears a few seconds later.

NOTE

•When “DOLBY D” or “DTS” is selected, if a signal encoded with another digital format comes in, you cannot listen to the sound. (The GDIGITAL or C indicator flashes.)

35