Before requesting service for a problem, use this chart and see if | Playback (DVD Deck) | |
you can solve the trouble yourself. Small problems are often easily |
| |
solved, and this can save you the trouble of sending your unit off |
| |
The DVD deck can not be operated. | ||
for repair. | ||
● The DVD deck is not selected. | ||
| General | ||
]Press VCR/DVD repeatedly so that the DVD lamp lights up on | ||
| the unit. |
No power is supplied to the unit.
●The AC power plug is disconnected from the AC outlet.
]Connect the AC power plug to the AC outlet securely. ( pg. 17)
The remote control does not work properly.
]Remove the batteries, wait for 5 minutes or more, then load the butteries again.
●The setting of the remote control code is inappropriate.
]Set the same remote control code (1, 2, 3, or 4) on both the unit and the remote control. ( pg. 70)
●The batteries are discharged.
]Replace the dead batteries with new ones.
Dubbing from the external equipment is not possible.
●The source (another video recorder, camcorder) has not been
properly connected.
]Confirm that the source is properly connected.
●All necessary power switches have not been turned on. ]Confirm that all units’ power switches are turned on.
●The setting of the input channel position is inappropriate. ]Select the input channel position
corresponds to the input terminal connected to the external equipment. ( pg. 68)
●The record safety tab has been removed when dubbing to the cassette.
]Using adhesive tape, cover the hole where the tab was removed.
The
]Set “SUPERIMPOSE” to “OFF”. ( pg. 74, 76)
The unit does not operate.
●There are cases when the operation is prohibited on the disc.
●Lightning or static electricity may cause malfunction of the unit. ]Press 1 to turn the power off, then press the button again to
turn the power on.
Images do not appear on the TV screen.
●The TV receiver’s channel selector is not set to the video
channel or AV mode.
]If you are using the RF connection, set the TV receiver to the video channel.
]If you are using the AV,
●The unit’s video channel has not been correctly set. ]Perform the video channel set. ( pg. 17)
●When interlace scanned program is played back, progressive
scan mode is selected.
]Press and hold PROGRESSIVE SCAN until 
disappears from the front display panel.
Playback dose not start or stop immediately after playback is
started by pressing 
.
On the front display panel, “NO DISC” appears.
●The disc is loaded upside down.
]Place the disc on the disc tray with the playback surface facing downward. ( pg. 11)
●A disc not being compatible with the unit is loaded. ]Load a playable disc on the unit. ( pg. 8)
●A dirty disc is loaded.
●Defective disc is loaded.
]Replace the warped or scratched disc with a normal one.
Images are blurred or distorted when you start
]Images are blurred or distorted at the point where the playback speed changes and this is not a malfunction of the unit.
Playback does not start.
]Playback does not start for approximately 30 seconds after recording is stopped and this is not a malfunction of the unit.
Playback does not start when you select a title or a chapter.
●The Parental Lock is engaged and the disc is rated higher than the set level.
]Release the Parental Lock temporarily or change the set level. ( pg. 37)