EDITING EN 67
| Edit From A Camcorder |
| Slide the TV/CABLE/DBS/DVD switch to DVD. | ||
|
|
|
| ||
|
|
|
|
| |
|
|
|
| 1 Make connections. | |
You can use a camcorder as the source player and your unit as the | |||||
| A If the camcorder has no | ||||
recording deck. |
| ||||
| — connect the camcorder’s AUDIO/VIDEO OUT connectors to the | ||||
|
|
|
| ||
| A If the camcorder has no | unit’s AUDIO/VIDEO input connectors on the front panel. |
| ● When using a monaural camcorder, connect its AUDIO OUT |
AUDIO/VIDEO input | connector to the AUDIO L input connector on your unit. |
B If the camcorder has an | |
| only) |
| — connect the camcorder’s AUDIO OUT and |
| connectors to the unit’s AUDIO and |
| the front panel. |
| 2 Press VCR/DVD repeatedly to select the recording deck. |
Recorder | 3 Press CH +/– to select |
| ● Set “FRONT AUX |
| |
| connector being used. ( pg. 74) This setting is also applied to the |
| VCR deck. |
Audio/video cable (supplied)
AUDIO/VIDEO OUT
Player
BIf the camcorder has anAUDIO input
Set “PICTURE CONTROL” to the appropriate mode. ( pg. 75)
5
6 Start playback on the camcorder slightly before the actual point from where you wish to start dubbing.
7 Press 7 on the unit to start recording. Or press and hold 7 and press 4 on the remote control. The dubbing starts.
8 Press 8 on the unit, then stop playback on the camcorder.
NOTES:
●All necessary cables can be obtained from your dealer.
●Refer to the camcorder’s instruction manual for operating procedure.
●The quality of dubbed picture becomes poorer than that of the original.
●When you select “EDIT” to dub tapes in step 4, be sure to select
“AUTO” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”) after you finish dubbing the tapes.
Recorder
Audio cable (supplied)
AUDIO OUT
(supplied) | Player |