Connecting the Center speaker
•To connect the center speaker, use the same type of speaker cord (6 m; tagged with “FRONT SPEAKER”) as used for connecting the front speakers.
•Each speaker cord has its name tag attached to one end. Attach the end without the name tag to the speaker terminal.
Insert the speaker cord into the speaker terminal.
1Press and hold the clamp.
2Insert the exposed core of the speaker cord fully into the terminal.
•Connect the cord with the black stripe to the · terminal.
3Release your finger.
1 2 3
Additional Information
Connecting the speaker system to the amplifier
Before connecting—
•Turn off the power to the amplifier before connecting the speaker system; otherwise, the speakers may be damaged.
•The impedance of each speaker is 8 Ω. Before connecting them to your amplifier, check the speaker impedance range of your amplifier. If the impedance of this speaker is out of the speaker impedance range indicated on the amplifier, you cannot connect this system to the amplifier.
•The maximum power handling capacity of the
•Be sure to turn down the volume level to prevent unwanted noise before performing following operations:
–Turning on or off other components,
–Operating the amplifier,
–Tuning FM stations,
–
–Continuously reproducing high frequency oscillation or high pitch electronic sounds.
•When using a microphone, do not aim it at the speakers or use it near the speakers; otherwise, the howling which occurs may damage the speakers.
•Before replacing the cartridge, always turn off the power to the turntable; otherwise, the clicking noise may damage the speakers.
English
The cord with the black stripe.
Typical connection method to an amplifier
Connect the speakers to a “SPEAKER” terminal of the amplifier with the speaker cords by referring to the diagram below.
•Make sure to match the polarity (ª and ·) when connecting the speaker cords.
•The diagram below is an example of a typical connection method.
Front right | Front left |
speaker | speaker |
| Center speaker |
Make sure to match the polarity (ª and ·); otherwise, the sound will lose the surround effect.
After connecting, check that the exposed cores are fully inserted into the terminal.
(Approx. 6 m) |
|
(Approx. 6 m) | (Approx. 6 m) |
Rear right | RIGHT | LEFT | RIGHT | LEFT | Rear left |
FRONT |
| CENTER | REAR | ||
SPEAKERS |
| SPEAKER | SPEAKERS | ||
|
|
| |||
speaker |
|
|
|
| speaker |
CAUTION: SPEAKER IMPEDANCE
8 
16 
Speaker terminals
on the amplifier
(Approx. 15 m) | (Approx. 15 m) |
