Assembly
| Assembling the satellite speakers | 2 Join the leg to the stand. |
|
| ||
|
|
| ||||
Each speaker (except the center speaker) has been divided into | • | Rotate either the leg or stand so that the |
| mark on the | ||
| ||||||
three parts for shipment. Before using this speaker system, |
| |||||
| leg and the | mark on the stand are facing the same | ||||
assemble it first by following the procedure below. |
| |||||
| direction. |
|
|
| ||
|
|
|
|
|
| |
|
| • | Make sure to match the screw holes on the leg with those | |||
|
|
| on the stand so that they are aligned correctly. | |||
Speaker | Leg | Stand |
section |
|
|
•Prepare a Phillips screw driver.
Before assembling—
•Take care not to drop the stand while assembling; otherwise, it may cause damage to the floor or injury.
•Ensure enough space for assembly and installation.
•Place a large, thick cloth on the floor where you assemble the speaker, so you can protect the floor and the speaker itself.
•Use the speaker only after assembly is fully and correctly done.
Attaching the leg and the stand
1 Remove the terminal cover from the leg.
First remove the screw on the terminal cover, then detach the cover by pulling it upward.
•You will need to use the removed screw in step 5 on page 5.
Terminal cover
Screw
claws
grooves
Leg
mark
Leg
Stand
mark
3 Fix the leg to the stand with three of the supplied screws (long: M4 x 25 mm).
Leg
Stand
Screw
•Do not tighten each screw completely as you put them in place.
First put all screws in, then tighten them evenly and firmly.
It is recommended to place a cushion under the leg.
•You can tighten the screws easily by placing the leg horizontally.
Cushion
