JVC TD-W354 manual Playback

8

1 2 3

4 5 6 7 8 4 9

iCassette operation buttons (deck B)

		: Press to wind the tape quickly from right
		to left.
		: Press to wind the tape quickly from left to
		right.
	(stop)	: Press to stop the tape. Also press to stop
		both decks simultaneously during dub-
		bing.
PLAY		: Press to start playback/recording.
	REC/	: Press the PLAY button while pressing
REC MUTE		this button to start recording, and press
		to leave an appropriate non-recorded
		section. (See page 10.)
	PAUSE	: Press to stop the tape temporarily during
		recording and playback. Press the PLAY
		button to release the pause mode.
	(direction)	: Press to change the direction of tape
		travel.

oDOLBY NR button and indicators

Set to B or C for recording using the Dolby NR system or for playing back a tape that was recorded using the Dolby NR

system. Each time the button is pressed the NR mode changes and the indicator lights. (Dolby B NR -> Dolby C NR -> NR OFF -> Dolby B NR ...)

Set to OFF when the Dolby NR system is not used.

pREVERSE MODE button

Select the single side or full record/playback mode, or the continuous play mode. Each time the button is pressed the

mode changes. ( -> -> -> ...) The current mode can be checked with the mechanism mode indicator.

: For single-side recording or playback.

: To play or record both sides A and B. : To play sides A and B continuously.

aA B SYNCHRO DUBBING buttons Press to dub from deck A to deck B.

·NORM SPEED : Press to perform normal-speed dubbing.

· HIGH SPEED : Press to perform high-speed dubbing.

PLAYBACK

1	POWER
POWER
ON OFF	STANDBY / ON
(B version)	(J version)
2
	A

3	4	DOLBY NR
		B C

5	REVERSE	6
	MODE

PLAY

Playback of deck A

Operate in the order of the numbers in the illustration.

1Turn the power on.

2Load a prerecorded cassette with side A facing out.

3 Select the side to be played back.

Side A... Forward direction (PLAY )

Side B... Reverse direction (PLAY)

4 Press the DOLBY NR button to set the same setting as when

the tape was recorded.

5 Select the REVERSE MODE.

6 Press the PLAY button of deck A to start playback.

· When the deck contains a tape, it can be played back by just pressing the PLAY button in the B version only when the POWER switch is set to ON and the switch is at STANDBY. In the J version, the tape can be played back by pressing the PLAY button only when the POWER switch is set to STANDBY.

Playback of deck B

Perform steps 2 to 6 of the above procedure for deck B.

Microphone mixing during playback

By connecting a microphone, microphone mixing with playback sound from deck A or deck B is possible.

Continuous play

First press the REVERSE MODE button to set to .

Load cassette tapes in both decks and press the PLAY button of the deck to be played first for continuous play of both decks.

·At this time, the CONT indicator lights in the multimode display. When the tape in the deck which plays first reaches the end of side B (in the reverse direction), it automatically switches to the forward direction and enters the standby mode. At the same time, the other deck starts playback. These operations con- tinue between decks A and B.

·While one deck is playing back, the cassette in the other one can be replaced. This is convenient for long-time playback of background music.

Note:

·Use tapes recorded using the same NR mode in decks A and B.

± 7 ±