INTRODUCTION

1.3 Names of Camera Parts

a

b

Figure 1-1 Camera parts

1.Conduit hole used for surface run power/video connector

2.Bottom case

3.Camera housing

4.Dome cover

5.IR board

a. AC 24V / DC 12V power input connector (red +, black -) b. Video output connector

Note: See Figure 2-3 for camera board controls.

1.4 Routine Maintenance

The dome cover is an optical part. Use a soft, dry cloth to remove any fingerprints or dust.

Clean the camera housing with a soft, dry cloth. For more stubborn stains, use a cloth dampened with a small quantity of neutral detergent, then wipe dry.

Caution: Do not use volatile solvents such as alcohol, benzene or thinners to avoid

damaging the surface finish.

4

Page 6
Image 6
JVC TK-T2101RU, TK-T2101RE manual Names of Camera Parts, Routine Maintenance