Advanced Disc Operations (see pages 13 and 14)
Programming the Playing Order—Program Play:
•You cannot specify a group number of an MP3 disc for Program Play.
•If you try to program the 100th track, “FULL” appears on the display.
Recording Operations (see page 15)
Recording on a Tape:
•The recording level is automatically set correctly. Thus, you can adjust the sound without affecting the recording level.
•There is leader tape which cannot be recorded onto at the start and end of cassette tapes. Thus, when recording from CD or radio broadcast, wind the leader tape first to ensure that the recording will be made without any music part lost.
•If you try to start recording with no cassette inserted or with a protected tape, your request will be ignored and
“NO REC” appears on the display.
Synchronized Disc Recording:
•When the tape reaches its end while recording, recording stops even though the disc is not entirely recorded.
•You cannot open the disc tray while recording from CD.
–If you press 0 button while recording from CD, “REC” appears on the display.
•You cannot activate Repeat Play while recording.
To protect your recording
Cassettes have two small tabs on the back to protect from unexpected erasure or
To protect your recording, remove these tabs.
To re-record on a protected tape, cover the holes with adhesive tape.
Timer Operations (see pages 16 and 17)
•When you unplug the AC power cord or if a power failure occurs, the timer will be canceled. You need to set the clock first, then the timer again.
•Without stopping the recording, you cannot change the source after Recording Timer starts recording.
•If you set Sleep Timer after Recording Timer starts recording, recording continues until Sleep Timer turns off the power.
Troubleshooting 
If you are having a problem with your System, check this list for a possible solution before calling for service.
General:
Adjustments or settings are suddenly canceled before you finish.
]There is a time limit. Repeat the procedure again.
Operations are disabled.
]The
Unable to operate the System from the remote control.
]The path between the remote control and the remote sensor on the System is blocked.
]The batteries are exhausted.
No sound is heard.
]Speaker connections are incorrect or loose.
]Headphones are connected.
Radio Operations:
Hard to hear broadcasts because of noise.
]Antennas connections are incorrect or loose.
]The AM loop antenna is too close to the System.
]The FM antenna is not properly extended and positioned.
19