To assemble and connect the AM loop antenna
To assemble the AM loop antenna
To connect the AM loop antenna
1 Press and hold 2 Insert | 3 Release |
•If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl.
•Make sure the antenna conductors do not touch any other terminals, connecting cords or power cord. Also keep the antennas away from the metallic parts of the System, connecting cords, and the AC power cord. This could cause poor reception.
Changing the Scanning Mode | Remote |
ONLY |
This System supports progressive scanning.
If you connect a progressive TV through the COMPONENT jacks, you can enjoy a high quality picture from the
PROGRE
INTER 
(at the same time)
PROGRE | Progressive scanning. |
(Progressive) | For a progressive TV. The |
| PROGRESSIVE indicator lights. |
|
|
INTER | Interlaced scanning. |
(Interlaced) | For a conventional TV. |
|
|
Selecting the Video Signal 
After connecting the TV, set the video signal type correctly for your TV. The VIDEO OUT SELECTOR is on the back of the System
•Make sure the System is not yet turned on. If it is already turned on, turn off then on again so that the selector setting becomes active.
To connect the speaker cords
Connect the right speaker to the R terminals, and the left speaker to the L terminals.
1 Press and hold 2 Insert | 3 Release |
When connecting the speaker cords, match the polarity of the speaker terminals: gray cord (+) to red (+), and gray cord with black stripe
• DO NOT connect more than one speaker to each terminal.
•DO NOT allow the conductor of the speaker cords to be in touch with the metallic parts of the System.
RGB Select for sending composite video signals or RGB signals through the SCART terminal.
Y/C Select for sending
Connect only component video cord or SCART cable at one time. SCART cable can convey composite video signals, RGB signals, and
6