Common Operations
Continued
Setting the Clock
Before operating the unit any further, first set the unit’s clock. When you plug in the power cord, the CLOCK indicator and “0:00” start flashing on the display.
You can set the clock whether the unit is on or off.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start over from step 1.
On the remote control:
1 Press CLOCK/TIMER. | CLOCK |
/ TIMER |
The hour digits start flashing on the display.
CLOCK
UP
2Press 
UP or 
DOWN to adjust the hour, then press
To check the clock time during play
On the remote control ONLY:
Press DISPLAY | DISPLAY |
• Each time you press the button, the source indication and the clock time alternate on the display.
•When you unplug the power cord or if a power failure occurs
The clock is reset to “0:00” right away. If this happens, set the clock again.
•The clock may gain or lose 1 to 2 minutes per month If this happens, reset the clock.
To change the clock
1 | Make sure the (timer) indicator is not lit on |
| the display. |
| • If it is lit, press and hold CLOCK/TIMER (or |
| TIMER/SNOOZE on the unit) until it goes off. |
2 | Press CLOCK/TIMER (or TIMER/SNOOZE |
CLOCK/TIMER.
DOWN
on the unit) repeatedly until the unit enters the |
The minute digits start flashing.
CLOCK
CLOCK / TIMER
3Press 
UP or 
DOWN to adjust the minute, then press CLOCK/TIMER.
clock setting mode (the hour digits start flashing |
on the display). |
First time you press CLOCK/TIMER (or TIMER/ |
SNOOZE on the unit), the unit enters the timer |
setting mode. (See page 20.) |
3 Repeat steps 2 and 3 of the procedure of |
“Setting the Clock.” |
4 Press and hold CLOCK/TIMER (or TIMER/ |
SNOOZE on the unit) again so that the |
(timer) indicator goes off. |
CLOCK
On the unit:
1Press TIMER/SNOOZE.
The hour digits start flashing on the display.
2Press ¢ or 4 to adjust the hour, then
press TIMER/SNOOZE.
The minute digits start flashing.
TIMER/SNOOZE
TIMER/SNOOZE
3Press ¢ or 4 to adjust the minute, then press TIMER/SNOOZE.
10
