Common Operations
Setting the Clock
Before operating the unit any further, first set the clock built in this unit. When you plug the AC power cord into the wall outlet, “0:00” starts flashing on the display.
You can set the clock whether the unit is on or off.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
1 | Press CLOCK/TIMER. | CLOCK | ||
/TIMER | ||||
|
|
| ||
| The hour digits start flashing on the display. |
| ||
|
|
|
| |
|
|
|
| |
|
|
|
| |
|
|
| CLOCK/TIMER | |
2 |
|
|
| |
|
|
| ||
Press UP or DOWN to adjust the |
| |||
| hour, then press CLOCK/TIMER. |
| ||
| The minute digits start flashing on the display. |
|
UP | DOWN | UP |
DOWN |
|
|
CLOCK | CLOCK/TIMER |
|
/TIMER |
| |
|
|
3 Press UP or DOWN to adjust the minute, then press CLOCK/TIMER.
To check the clock time during play
On the remote control ONLY:Press DISPLAY. | DISPLAY |
|
• Each time you press the button, the source indication and the clock time alternate on the display.
•When you unplug the AC power cord or if a power failure occurs
The clock is reset to “0:00” right away. If this happens, set the clock again.
•The clock may gain or lose 1 to 2 minutes per month If this happens, set the clock again.
To adjust the clock again
1Make sure (timer) indicator is not lit on the display.
•If it is lit, press and hold CLOCK/TIMER until it goes off.
2Press CLOCK/TIMER repeatedly until the unit enters the clock setting mode (the hour digit start flashing on the display).
First time you press CLOCK/TIMER, the unit enters the timer setting mode.
•See pages 19 and 20.
3Repeat steps 2 and 3 of the procedure of “Setting the Clock.”
4Press and hold CLOCK/TIMER again so that (timer) indicator goes off from the display.Turning On the Power
When you press the play
To turn on the unit, press | STANDBY / ON | |
|
| STANDBY/ON |
STANDBY/ON | . |
|
The STANDBY/ON lamp lights green and “HELLO” appears on the display.
To turn off the unit (on standby), pressSTANDBY/ON again.
The STANDBY/ON lamp lights red and “GOOD BYE” appears on the display.
•“0:00” flashes on the display until you set the
•A little power is always consumed even while the unit is on standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs
The clock is reset to “0:00” right away, while the tuner preset stations (see page 11) will be erased in a few days.
Selecting the Sources and Starting Play
To play back CDs, press CD 3/8. (See pages 13 – 15.) To play back tapes, press TAPE 2 3. (See page 16.)
To listen to FM/AM (MW/LW) broadcasts, press FM/AM.(See pages 9 – 10.)
To select the external equipment as the source, press
AUX/MD.
3/8 | 23 |
|
|
CD | TAPE | FM/AM | AUX/MD |
When you press the play button for a particular source
(CD 3/8, TAPE 2 3, FM/AM and AUX/MD), the unit turns on (and the unit starts playing the source if it is ready).